luminii Plexineon Suspended Static Color Suspension Mount Instruction Manual
- June 3, 2024
- luminii
Table of Contents
luminii Plexineon Suspended Static Color Suspension Mount
Installation Instructions
Models: Plexin eon Fixture Suspension Mount Static Color and Plexin eon Rings Suspension Mount Static Color
Please read all instructions prior to installation and keep for future reference!
- PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN.
- USE ONLY WITH CLASS 2 POWER UNIT
- 24 VOLTS DC
- SUITABLE FOR WET LOCATIONS
- SUSPENDED MOUNT ONLY
Plexineon Straight Run Fixture
Plexineon Ring Surface Mount
NOTE: Prior to installation all 24VDC wires must be present within 72” of
the installation. Refer to the power supply installation instruction for
additional information.
NOTE: More than one person is recommended for this installation.
Screw mounting clip to stand off hub. Use plunger to adjust the length of
aircraft cable.
Fix the plexineon fixture into installed mounting clips. See step A for
clipping instructions. Make sure mounting clips are certain distance apart
NOTE: Standard Clips and Decorative Clips have different required spacing
Install Fixtures into Mounting Clips
A . 1 Make an U shape with mounting clip installation tool, insert two
edges into mounting clip. Place plexin eon fixture inside the shape. Then push
the fixture into clip.
A.2 Remove the tool. Make sure mounting clip is clipped right on the
grip.
NOTE: Prior to installation all 24VDC wires must be present in junction
box. Refer to the power supply installation instruction for additional
information.
Align one standoff hub to the junction box and mark the other hubs’
**location to the ceiling.
**
Slide power cord end through strain relief, canopy, and cross bar. Peel
back power cord to expose wires. Connect strip (24VDC+) and black (24VDC-)
power supply wires to fixture red and black wires. Waterproof wire nuts
recommended in this step
NOTE: Prior to wiring the desired fixture height must be determined to cut
off any un-necessary wire.
Insert wire nut and extra wire into junction box. Slide weld stud into the
center hole of cross bar. Screw cross bar into junction box holes or the
ceiling.
Slide canopy up to the cross bar and secure by tightening the thumb nut to
weld stud.
Screw cap to threaded post with aircraft cable.
Fix the aircraft cable into thumbnut, secure by tightening by hand.
Install the rest of other canopies by similar method.
If necessary, make any final adjustment to power cord using cable clip.
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>