McLED ML-910.021.22.0 RF Dimmable Driver Instruction Manual
- June 4, 2024
- McLED
Table of Contents
RF dimmable driver
ML-910.021.22.0
www.mcled.eu
Important: Read All Instructions Prior to Installation.
Installation may only be performed by qualified persons.
Function introduction
Product data
| Selectable Current | 250 – 1500 mA |
|---|---|
| Output Voltage | 8 – 48 V DC |
| Rated Power | 50W |
| Input Voltage | 200 – 240V AC (50Hz) |
| Working Temperature | -20 °C ~ +45 °C |
| PF | >0,9 |
| Dimension | 210 x 50 x 32 mm |
- Short Circuit Protection
- Over Voltage Protection
- Over Temperature Protection
Safety & Warnings
- Do NOT install with power applied to the device
- Do NOT expose the device to moisture
Dips to set the operation current
- Dimmable LED driver with RF control, dimming range 0,1% – 100%
- Max. output power 50W
- 1 channel 250 – 1500 mA constant current output
- Dips to set the operation current
- Class II power supply, full isolated plastic case
- High power factor and efficiency
- To switch and dim single-color LED lighting
- Compatible with a variety of single-color RF remotes
- IP20 rating
- Suitable for indoor LED lighting applications
- Radio Frequency: 868 Mhz
Installation
Pairing with RF remote
- Do wiring according to the connection diagram.
- Pair RF Receiver with RF remote: please refer to the instruction of the remote that you would like to pair with.
Restore factory settings
- Wire up the RF receiver correctly, and power on.
- Press and hold down the “ Learning Key” button on the receiver for over 5 seconds until the connected light flashes, which means well deleted.
Wiring diagram
PUSH DIM: While connected to LV, click the button to switch ON/OFF
lights. Press and hold down the button to Increase/ decrease light intensity.
*When the lifetime of this product will run out, please hand it into the places for electro-waste.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>