ALEASHA 3080500-US Free Standing Tub Faucet Instruction Manual

Table of Contents

ALEASHA-3080500-US-Free-Standing-Tub-Faucet-FIG-1

For easy installation of your faucet you will need:

For easy installation of your faucet you will need:

To READ ALL the instructions completely before beginning.
To READ ALL warnings, care, and maintenance information.
With 1.8 gpm are compliant with California water efficiency regulations, comply \with California Proposition 65 and the Federal Safe Drinking Water Act.
Water Use Information: 1.8 gpm 6.8L/min,
You can choose to replace the current-limiting device and face the water pipe square.

Care should be given to the cleaning of this product. Although its finish is extremely durable,
It can be damaged by harsh abrasives or polish.
To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.

ALEASHA-3080500-US-Free-Standing-Tub-Faucet-FIG-3

Place the flange over the standpipe and push it to the base.
Connect the brass base seat to the standpipe, and fasten the base seat and standpipe with an alien key.
- Place the water inlet supply hoses to the standpipe

Ture the inlet supplies to a mixer, verify the hot one with the red line and the cold one with the blue line.
Attach the mixer to the standpipe(#3).
Tighten the hot and cold inlet hoses to a mixer, fasten the mixer with a standpipe with screws.
Mark the locations for the screws with a pencil With an electric drill, drill 4 holes for the expansion screws in the floor.
Place the expansion screw into the holes. Connect the flexible supply lines to the water supplies.
Ensure the standpipe sits flush against the finished floor surface. Then secure the standpipe using screws.
Push the escutcheon over the standpipe base so that it sits flush against the finished floor surface.
Connect one end of the shower hose to the mixer and the other end to the showerhead .
Twist here to switch OFF to shower Pull the hose to its furthest extension and hold it down into the tub.
Turn on hot and cold water supplies and flush water lines for one minute.
Turn the faucet handles on. Twist here to switch OFF to BATH Turn on hot and cold water supplies and flush water lines for one minute.
Important: This flushes away any debris that could cause damage to internal parts.
FLUSH SYSTEM/CHECK FOR LEAKS. Turn on hot and cold water supplies and flush water lines for one minute.
Check all connections at arrows for leaks.
Retighten if necessary, but do not overtighten.