Enduro Engineering 24-4020 Beta Skid Plate Installation Guide

: June 12, 2024
: Enduro Engineering

Table of Contents

Enduro Engineering 24-4020 Beta Skid Plate
BETA SKID PLATE INSTALLATION INSTRUCTIONS
WARNING AND DISCLAIMER
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Enduro Engineering 24-4020 Beta Skid Plate

Enduro-Engineering-24-4020-Beta-Skid-Plate-PRODUCT

BETA SKID PLATE INSTALLATION INSTRUCTIONS

Use an 8mm wrench and/or socket to remove the two bolts holding on the OEM plastic skid plate. (fig. 1 and 1.1)
Using the provided 6x25mm hex head bolt, install the rear section of the skid plate to the rear mount on the frame do not tighten at this time. (fig 2)
Using the provided 6x16mm hex head bolt, install the front protection plate do not tighten at this time. (fig 3)
Install the provided front mounting bracket into position. Install between the frame rails and engine cases by sliding one end up between the engine case and frame with the longer side to the throttle side of the bike, then pulled back so that the bracket rests on both frame rails. (fig 4 and 4.1)
Position the EE skid plate up against the frame and the front protection plate of the skid plate. Using the two provided 8x45mm flat head bolts, fasten the plate to the front bracket, and do not tighten at this time. (fig. 5)
Starting from the rear of the bike to the front tighten all bolts while pressing the plate up against the bike.
Have fun and ride safe!

WARNING AND DISCLAIMER

All parts manufactured, designed or sold by Enduro Engineering, Inc. (EEI) are to be installed by a licensed motorcycle dealer or a licensed motorcycle technician, Motorcycles can be dangerous. Serious injury, death and property damage can result from the use of motorcycles. This risk is increased by improper installation or misuse of after-market parts. EEI’s customers must exercise good judgment in the use, control, alteration, part selection and installation, and maintenance of their motorcycles. In the event of a possible defect in material or design, or any other defect in a part manufactured, designed or sold by EEI, the responsibility of EEI is limited to either a refund of the purchase price or the replacement of the part if EEI determines the part to be defective, and subject to EEI’s inspection of the part within thirty (30) days from the date of purchase. (Note: any attempted repairs or modifications made to EEI Products will void this limited warranty.) EEI, under no circumstances will be responsible for incidental and/or consequential damages, property damage, personal injury damage, or damage, injury, cost or expense of any kind or nature whatsoever. By purchasing as EEI product or a product sold by EEI, you (1) acknowledge the above disclaimer and agree to its terms; (2) agree that any claim brought against EEI arising from and/or pertaining to or otherwise related to a part manufactured, designed or sold by EEI must be brought in the Michigan State Courts located in the County of Ingham or in the Federal District Court for the Western District of Michigan and the Michigan law shall apply on all issues; and (3) any claim against EEI must be brought within one (1) year of purchase of the product. EEI makes no other warranty, express or implied, including without limitation any warranties of merchantability and fitness for a particular purpose.