H Koenig joe50 Silent Retro Metal Desk Fan Instruction Manual

: June 5, 2024
: H Koenig

Table of Contents

SPECIFICATIONS
WIRING DIAGRAM
INSTALLATION DIAGRAM
INSTRUCTIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

joe50 Silent Retro Metal Desk Fan
Instruction Manualhttps://goo.gl/fw5nnz

SPECIFICATIONS

POSITION 1	POSITION 2	POSITION 3

Current
(A)| Power
(W)| PRM
r/min| Noise
dB(A)| Current
(A)| Power
(W)| PRM
r/min| Noise
dB(A)| Current
(A)| Power
(W)| PRM
r/min| Noise
dB(A)
0.11| 24| 1020| 41| 0.13| 28| 1120| 43| 0.15| 33| 1230| 47

WIRING DIAGRAM

INSTALLATION DIAGRAM

INSTRUCTIONS

Before power is supplied to the fan, ensure that the voltage and frequency are the same as the nameplate.
Assembling the guard and the blades.
2.1. It is fixed the back guard on the motor by the mounting screw.
2.2. It loosened the cap nut. Fixes the blades on the rotor shaft by locking the blade’s screw. Finally locked the cap nut into the rotor shaft.
2.3. It fixed the front guard on the back guard by locking the guard’s screw.
The switch has buttons numbered 0, 1, 2, and 3, including off, slow, medium, and fast, respectively.
The oscillation switch controls the swing of the fan.

ATTENTIONS

Unplug the fan before maintenance. Do not touch the fan if your hands are wet.
Do not connect to the main power supply or switch on the fan before assembly is completed.
Those who are not qualified electricians should not disassemble, repair or rebuild the fan.
Unplug the fan when it is not being used.
Do not unplug the fan by holding the wire.
Do not use the fan if the wire or plug has been damaged, or if the power socket is loose.
Do not repair the fan when the wire is damaged.
Do not use the fan near any of the following: gas stove or any fire source, unusually humid or high temperatures, oil soot with a lot of metal powder, or unstable places not good for oscillation.
Do not insert your hand into the guard, or movable parts.
To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
This appliance may be used by persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge, provided that they are supervised or instructed in the safe use of the appliance and that they fully understand the potential hazards.
Children should be supervised to ensure that they do not play with the appliance.
If the power cord is damaged, it must be replaced with after-sales service to avoid any danger.
This device is not intended for use by persons with reduced capacity on the physical, mental or sensory or lack of experience and knowledge (including children), unless he has them was asked to monitor or if they have had instructions on the use of the appliance by a person responsible for their safety. Children should be supervised to ensure they do not play with the device.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
Ensure that the fan is switched off from the supply mains before removing the guard.
Young children should be supervised if the wire is damaged. It must be replaced by the manufacturer, its reduced agent or similarly qualified persons in order to avoid a hazard.
The device must not be used if it has been dropped, it obvious signs of damage are visible.
This appliance may be used by children of at least 8 years of age, as long as they are supervised and have been given instructions about using the appliance safely, and are fully aware of the dangers involved.
Cleaning and maintenance should not be carried out by children, unless they are at least 8 years of age and are supervised by an adult.
Keep the appliance and its power cord out of reach of children under 8 years of age.
When using electrical equipment, safety precautions must always be taken to prevent the risk of fire, electric shock and/or injury in the event of misuse.
Make sure that the voltage rating on the typeplate corresponds to the main voltage of your installation. If this is not the case, contact the dealer and do not connect the unit.
Never leave the unit unattended while in operation.
Please keep this document at hand and give it to the future owner in case of transfer of your device.
The device is not intended to be operated by external timer means or a remote control system.
This appliance is only intended for domestic and indoor use.
Young children, the elderly, or the suffering should not be exposed to direct breath of the ventilator for a long time.
Never immerse in water or any other liquid, the appliance, its power cord, or the socket-outlet

ENVIRONMENT
CAUTION:
Do not dispose of this product as it has with other household products. There is a separation of this waste product into communities, you will need to inform your local authorities about the places where you can return this product. In fact, electrical and electronic products contain hazardous substances that have harmful effects on the environment or human health and should be recycled. The symbol here indicates that electrical and electronic equipment should be chosen carefully, a wheeled waste container is marked with a cross.

Adeva SAS / H.Koenig Europe – 8 rue Marc Seguin, 77290 Mitry-Mory, France
www.hkoenig.com – https://en.hkoenig.com – Tél: +33 1 64 67 00 05