McLED 2277285 Outdoor Lights Installation Guide
- June 12, 2024
- McLED
Table of Contents
McLED 2277285 Outdoor Lights Installation Guide
ASSEMBLY INSTRUCTIONS
OUTDOOR LIGHTS
Please read these instructions carefully before starting the assembly and follow the recommended procedures.
Product application: This product is intended for outdoor use and wall and ceiling mounted or stand-alone installation.
Procedure
-
1. Familiarise yourself with the instructions before starting the assembly.
2. The installation should be performed by a person qualified for working
with electrical equipment.
3. All tasks must be carried out with disconnected power supply.
4. Description of installation:
4.1 Pull the cable through the bushing and attach the lamp cap.
4.2 Connect the power supply wires to the prepared screw terminal
according to the symbols on individual wires of the power supply cable.- L – Phase
- N – Neutral
- Protective earth
-
Attach the cover to the lamp cap and tighten the fastening screws.
-
Make sure that the mechanical and electrical connections are correct before using the light for the first time.
-
Check the light function.
Operating instructions / maintenance
- Do not use chemical cleaning agents.
- Do not cover the product.
- The product must not be heated above the recommended temperature.
- The product must not be used if the protective glass is cracked.
- The product uses an LED type of light, which is not replaceable.
- The product cannot be repaired if the light source is damaged.
- CAUTION: Do not look directly into the LED rays.
Functional properties
- The product has enhanced resistance against mechanical impact.
- The product belongs to the category of energy-saving goods.
Notes / recommendation
- A failure to observe these instructions may cause fire, burns, electrical injuries, physical injuries and other material and immaterial damage.
- Additional information about McLED products is available at: www.mcled.cz
- McLED will not be liable for any damage caused by a failure to observe these instructions.
This product contains a light source in the power saving class (see above).
Exchange possibilities: (1) the light source cannot be exchanged. The
luminaire must be replaced with a new one. (2) the gearbox may be replaced by
a responsible person with corresponding qualications without permanently
damaging the luminaire
Costumer Support
GEO McLED s. r. o. Videriska 185, CZ – 252 50 Vestec
Tel.: +420 220 184 800 e-
mail: office@mcled.cz
www.mcled.cz
0 Schmachtl GmbH PummererstraBe 36, A – 4020 Linz
Tel.: +43 732 7646 0 e-
mail: office@mcled.at
www.mcled.at
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>