luminii LLRGBW36-XX Dynamic Color LineLED Strip Instruction Manual
- June 3, 2024
- luminii
Table of Contents
LineLED Wet 24V – Installation Instructions
Models LLRGBW36-XX
LLRGBW36-XX Dynamic Color LineLED Strip
Please read all instructions prior to installation and keep for future reference!
- PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT FUSE BOX PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR DAMP LOCATIONS
- FOR UNDER CABINET OR SHELF MOUNT
- CONFORMS TO UL STD 2108. CERTIFIED TO CSA STD NO. 250.0.
ATTENTION: ALWAYS TEST LLRGBW36 BEFORE INSTALLING. CONNECT LLRGBW36 TO
POWER SUPPLY TO ENSURE IT IS WORKING PROPERLY
AND NO DAMAGE HAS OCCURRED DURING SHIPPING.
1.1 Clean area thoroughly where tape will be installed.
For rough surface installations, it is recommended to apply a layer of
Aluminum tape or similar material prior to tape application.
NOTE : Avoid bending the LLRGBW36 in sharp horizontal angles which may
damage the LEDs
NOTE – Avoid bending near 1” on both side of the soldered joints.
2.1 Remove the paper backing from the LLRGBW36 and firmly press down making sure there are no air bubbles that can cause surface irregularities. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.
2.1 If required for installation, cut the LLRGBW36 strip between two rows of solder pads. Always cut LLRGBW36 from end without connector / wire leads.
1.0
NOTE: FPO
NOTE: FPO
NOTE: FPO
NOTE: FPO
NOTE: FPO
NOTE: FPO
NOTE: FPO
NOTE: FPO
1.1 FPO Description.
1.2 FPO Description.
Complete Parts List:
- FPO
- FPO
- FPO
- FPO
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
REV0.4
08252022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>