LUMEX SKYBAY Canopy Installation Guide

: June 3, 2024
: LUMEX

Table of Contents

INSTALLATION INSTRUCTIONS
SEVEN YEAR WARRANTY AGAINST DEFECTS
- LUMEX Lighting (Australia Only)
CUSTOMER SERVICE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LUMEX SKYBAY Canopy

INSTALLATION INSTRUCTIONS

Skybay Canopy Range

Ensure that the power has been isolated before attempting installation
Ensure the desired location is suitable and clear of all obstructions

Surface Mount Installation

Remove luminaire from housing
Use the housing to mark the hole centres for fixing.
Drill holes according to hole centres (a).
Install a suitable standard three pin socket (240V 10A) adjacent to the mounting point
Note: Skybay Canopy has a 1.2m flex and plug provided
Fix housing to ceiling using suitable screws
Connect lanyard between housing and luminaire
Plug Skybay Canopy into three pin socket or terminate supply wiring to the luminaire in an approved manner
Check seals, gaskets and cable glands to ensure in good order
Refit luminaire to housing
Energise and test luminaire

Recessed Installation

Cut opening for Skybay Canopy.
Note: Minimum opening required is 385mm x 385mm. Maximum opening allowed is 400mm x 400mm
Install a suitable standard three pin socket (240V 10A) adjacent to the mounting point
Note: Skybay Canopy has a 1.2m flex and plug provided
Plug Skybay Canopy into three pin socket or terminate supply wiring to the luminaire in an approved manner
Push Skybay canopy into opening
Use screws to adjust keeper plates to suit ceiling thickness (b).
Energise and test luminaire

WARNING: RISK OF ELECTRIC SHOCK
This product shall be installed by a licenced electrician in compliance with the requirements set out in AS/NZS 3000 (current edition) and other relevant Standards and Regulations pertaining to the installation. This product must only be used for the purpose outlined in this instruction manual. Failure to follow these instructions may result in serious injury or death. Prior to installing this product, check whether the product has been damaged during transport. Do not operate/ install the product if damaged in any way. Return complete product to the place of purchase for inspection, repair or replacement.

SEVEN YEAR WARRANTY AGAINST DEFECTS

LUMEX Lighting (Australia Only)

With your new Lumex product comes the quality assurance provided by the seven (7) year or 35,000 operational hour Warranty (the “Warranty”) The warranty is offered to you by Verbatim Australia (the “Company”) Pty Ltd of Unit 6, 450 Princes Highway Noble Park, VIC, 3174. Subject to the terms of this document, Verbatim warrants to the owner of the Installation that Verbatim will repair or replace, without charge Lighting product (the “Product”) if the Product fails due to any operation following initial installation. This Warranty applies from the date of invoice for a period of seven (7) years or 35,000 hours of operation thereafter subject to the conditions set in this Warranty.

Definitions
In this warranty:

Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010.
Goods mean the product or equipment that was purchased in Australia.
Manufacturer, We or us means Verbatim Australia Pty Ltd ABN: 39 005 706 374.
Supplier means the authorized distributor or the licensed electrical contractor that sold you the Goods.
You means you, the original end-user purchaser of the Goods.

Warranty Period and Details

This product is covered by a seven (7) year or 35,000 hours of operation warranty against manufacturing faults and defects, provided that:
The product is properly installed, and installation is consistent with the manufacturer’s instructions, and is installed by suitably trained
The product is only used for the purpose of illumination, in line with its designated purpose or the designated purpose of a luminaire of its general type.
The product use is in normal conditions and not exceeding a total of 35,000 hours over the warranty period.
Any faults or defects attributable to the misuse, abuse, accident or non-observance of the manufacturer’s instructions on the part of
Where a battery product is installed, the warranty period covers 12 months.
Where a SmartSense™ product is installed, the warranty period covers seven (7) years for the sensor technology only.
Where a third party component is installed within, or as part of, a Equipment Manufacturer of the third party component

This Warranty DOES NOT COVER:

Damage caused by acts of god, or other incidents /occurrences beyond the control of Verbatim. including without limitation, fire, theft, storms. floods.
Damage caused by water or other forms of moisture being absorbed by the LED light fitting.
Damage caused by chemical impact or other abuse including environmental factors, improper cleaning solutions, damage from leaving substances such as bleach on the product.
Damage or problems caused by the use of an accessory, component or equipment not supplied by Verbatim.

Extent of the Warranty

Verbatim do not cover freight charges (including insurance).
The Owner will be responsible for all costs of returning Goods to the Company and for redelivery of the Goods (whether original or repaired and/or replacement Goods) by the Company and any other expenses of the Owner in claiming under the Verbatim warranty.
Goods that prove defective within the Warranty Period by reason of improper workmanship or faulty material, we may, at our own discretion, either repair or replace the Goods without charge.
This warranty does not cover any cost related to removal, or reinstallation of the replaced or repaired item. Any parts of the Goods replaced during repairs, or any product replaced, remain the property of Verbatim.
In the event of the Goods being replaced during the Warranty Period, the warranty on the replacement Goods will expire on the same date as the Warranty Period of the original Goods they are replacing.
This warranty is transferable to the original end user, non transferable after that.

Applicable Date/Commencement of Warranty
This warranty commences from the date of purchase from the point of purchase from Verbatim Australia Pty Ltd.The details of the point of purchase, as well as all contact information for warranty claims and queries, are detailed below:
Contact: Verbatim Customer Service
Address Verbatim Australia Pty Ltd
Unit 6, 450 Princes Highway Noble Park, VIC, 3174
Phone +61 3 9790 8999
Email customerservice@verbatim.com.au

Claim Process
The customer claim process is as follows:

The customer can lodge a claim through the wholesaler from where goods were purchased.
The customer must provide original proof of purchase from supplier.
The wholesaler/customer/end user must complete the online Warranty Claim Request via the skslighting.com.au website.
If accepted as a valid claim within the terms as described in this document, Verbatim will repair the product or provide an equivalent replacement product.

IMPORTANT
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.