luminii LETO 11 965 Slim Canopy Instruction Manual
- June 3, 2024
- luminii
Table of Contents
luminii LETO 11 965 Slim Canopy
- Feed Suspended P2
- Solid Stem P3
Read and follow these instructions before installing or maintaining this
product
- This product is suitable for DRY INDOOR LOCATIONS ONLY
- Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
- Allow air to flow freely around the fixture
- Do not switch on line voltage until all wiring is complete
- Incorrect wiring will result in irreparable damage to LED and power supply
- This product should only be installed by a licensed electrician
Warranty
- This product must be installed in accordance with all applicable installation codes and ordinance
- Limited five (5) years warranty
- Warranty is void in the eventuality of unauthorized modifications and/or improper use
Pendant: Single Feed Cable
- Make electrical connections. AC to ceiling and DC to fixture. Temperature Sensor (orange) is not used and should be capped.
- Place driver in junction box. Screw bracket onto junction box.
- Line up canopy with crossbar’s screw holes, slide onto ceiling.
- Secure canopy to junction box with two screws provided. Make adjustments to cable length, tighten cord grip cap.
- Straighten feed cable, removing any bends.
Pendant: Solid Stem
- Feed the wires through stem. Screw stem to Leto 11 Mini head.
- For each stem, add loctite to threads. Feed the wires through the other stem and screw each stem together
- Place driver in junction box. Screw bracket onto junction box.
- Re-assemble canopy with threaded nipple attached to the stem.
- Make electrical connections. AC to ceiling and DC to fixture. Temperature Sensor (orange) is not used and should be capped.
- Line up canopy with crossbar’s screw holes, slide onto ceiling.
- Secure canopy to junction box with two screws provided
403-216-7043 | info@sensolighting.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>