luminii LETO 44 Mini P 954 Semi-Recessed Canopy Installation Guide

Table of Contents

luminii LETO 44 Mini P 954 Semi-Recessed Canopy

luminii LETO 44 Mini P 954 Semi-Recessed Canopy

Read and follow these instructions before installing or maintaining this product

This product is suitable for DRY INDOOR LOCATIONS ONLY
Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
Do not switch on line voltage until all wiring is complete
Incorrect wiring will result in irreparable damage to LED and power supply
This product should only be installed by a licensed electrician

Warranty

This product must be installed in accordance with all applicable installation codes and ordinance.
Limited five (5) years warranty · Warranty is void in the eventuality of unauthorized modifications and/or improper use

Pendant: Single Feed Cable (AC Connection)

Finish ceiling installation. Make sure hole is cut to appropriate size and location. 54mm (2.125”)
Disassemble driver housing to expose the driver.
Make electrical connections and use appropriate strain relief.
Reassemble housing and insert into ceiling. Push aside to leave room for canopy
Connect dimming controls to included cable clamps. Insert wires and canopy into ceiling.
Turn screws until housing is secured in place (arms will rotate and clamp down on ceiling)
Unscrew gripper plate and separate from canopy.
Unscrew gripper plate and separate from canopy
Re-attach gripper to canopy and slide trim plate up until held in place by magnets.

Pendant: Single Feed Cable (Remote DC Connection)

Finish ceiling installation. Make sure hole is cut to appropriate size and location. 54mm (2.125”)
Disassemble driver housing to expose fixture wiring. Cylinder housing is used as DC junction box.
Make electrical connections and use appropriate strain relief.
Reassemble housing and insert into ceiling. Push aside to leave room for canopy.
Insert canopy into ceiling.
Turn screws until housing is secured in place (arms will extend and clamp down on ceiling)
Unscrew gripper plate and separate from canopy.
Loosen set screw and adjust cable to desired height. Cut and reconnect wire if needed.
Re-attach gripper to canopy and slide trim plate up until held in place by magnets.

Pendant: Powered Aircraft Cable (Remote DC Connection)

Finish ceiling installation. Make sure hole is cut to appropriate size and location. 54mm (2.125”)
Disassemble driver housing to expose the driver.
Make electrical connections and use appropriate strain relief.
Reassemble housing and insert into ceiling. Push aside to leave room for canopy.
Connect dimming controls to included cable clamps. Insert wires and canopy into ceiling.
Turn screws until housing is secured in place (arms will extend and clamp down on ceiling)
Slide trim plate up until held in place by magnets.

Pendant: Powered Aircraft Cable (Remote DC Connection)

Finish ceiling installation. Make sure hole is cut to appropriate size and location. 54mm (2.125”)
Disassemble driver housing to expose fixture wiring. Cylinder housing is used as DC junction box.
Make electrical connections and use appropriate strain relief
Reassemble housing and insert into ceiling. Push aside to leave room for canopy
Insert canopy into ceiling
Turn screws until housing is secured in place (arms will extend and clamp down on ceiling)
Slide trim plate up until held in place by magnets

Pendant: Powered Aircraft Cable (Remote DC Connection)

Remove trim plate from the canopy
Unscrew gripper plate separate from canopy.
Loosen set screw and adjust cable to desired height.
Cut excess cable leaving ~3” above gripper. Make electrical connections using appropriate hardware
If cables develop a twist, loosen set screw and cycle cable through the gripper 4-5 times.
Tighten screws, re-attach gripper plate to canopy and slide trim plate up until held in place by magnets.