CLAYMORE CLC2-4640BK ULTRA2 4640 Rechargeable Area Light User Manual
- June 3, 2024
- CLAYMORE
Table of Contents
CLAYMORE CLC2-4640BK ULTRA2 4640 Rechargeable Area Light
This portable light contains Li-ion batteries. Please follow the user manual before use. If any abnormality is found in the product, discontinue use and contact the dealer or a service center where the product was purchased. Any modifications to this product will void the warranty. Misuse of CLAYMORE products may cause user harm.
Caution
- Do not use near high temperatures such as fires or heating equipment. It may cause explosion and ignition.
- This product is water resistant. However, if left in the rain for a long time, it may cause malfunction.
- If the product gets soaked, please quickly wipe it off.
- Do not store or use in vehicles exposed to direct sunlight. It may cause explosion and malfunction.
- Do not touch the light source directly as it may become very hot during use.
- Do not use if the product exceeds the operating temperature range (-10 • C to 40 °C).
- Do not look directly into the LED light source.
- Please do not place in the reach of infants. It may cause swallowing of parts or injury.
- adult supervision is necessary when used by children. Misuse of the headlamp may cause injury or electric shock.
- Do not insert any metal parts into the terminal block of the connector. It may cause heat, explosion or electric shock.
- Do not disassemble or modify the product.
- Do not touch the connector with wet hands. There is a danger of electric shock.
- After use, be sure to turn off the power. If not, it may cause leakage.
- When adjusting the angle, please do not bend with force. It may cause damage to the product.
- Dropping or impacting the product can cause damage to the inside of the product, resulting in unexpected failures in normal use. Be careful not to apply impact to the body.
Parts & Components
Operating Manual
Charging
As shown in the figure, open the cover of the product and connect the USB
cable to the charging port. Charging time may vary depending on battery
capacity and the external environment.
When the product is being charged, the battery level indicator flickers. If
the light is not flicking and all the lights are on, it indicates that the
battery has been fully charged.
When the battery capacity is less than 4%, Battery check and power bank functions may not activate. * If the charging cable is plugged in when completely drained, the LED light will flash instantly. This is a normal phenomenon and is not a defect.
Operation
- On/Off & Dimming Push the on/off button shortly to turn off the lantern.
- Stepless Dimming Press and hold button to increase brightness. Press and hold the button to decrease brightness. Blinks once when Maximum and Minimum brightness is reached.
- 5-Step Dimming Push button shortly to increase brightness. Push button shortly to decrease brightness.
- press button once again to stop the SOS flash.
In Case of Malfunction
- If there is something wrong with the product, please check the following first.
- If it does not activate, check the charging status.
- If the external device can not be charged, check the On the state of the function button.
Specification
Contents
Caution for long-term storage
- If the battery is completely drained, the battery indicator might not flash. Manual
- If this happens, plug the USB cable back in or press the button to turn the battery indicator on again.
- For long-term storage, fully recharge the battery. (Repeat every six months)
- Please keep in mind that if stored below -1 o·c the battery life may be affected.
- Please keep in a dry place without moisture.
Power Bank Function
- Claymore ULTRA+ II model offers smart quick charge.
- Connecting multiple devices with a USB cable will automatically start charging. (On status: Battery indicator turns on)
- If the power bank is not working, press [±]or l=Jbutton once to activate it.
Instructions
- When making the lantern stand up on a flat surface You can place the lantern vertically or horizontally when configuring the lantern on a flat surface.
- Tum the metal handle to adjust the angle of lighting and place it on a flat surface to obtain desired lighting direction.
- When hanging on a lantern hook or string
- Turn the metal handle to adjust the angle of light in the desired direction
- When mounting the lantern on the camera tripod Unscrew the lantern hook from the handle. then mount the handle wire onto the camera tripod to fix it.
- Adjust the angle of the handle wire or the direction of the tripod to illuminate the desired spot.
Warranty
- Thank you for purchasing the CLAYMORE series of Prism Co., Ltd.
- This product has passed strict quality control tests. If the product is not functioning properly, please contact an authorized service center.
Free Service
- Failure of the product under normal operating conditions during the warranty period will be repaired by Prism or an authorized service center on free of charge. Some shipping or handling charges may be involved.
- Warranty period: 1 year.
Charged Service
- Damage is caused when the warranty period is over.
- Damage is caused due to the user’s mishandling, abuse, or improper operation.
- Damage caused by arbitrary or personal repair or disassembly in the unauthorized service center.
- Damage from input electricity or cable defect
- Damage caused by natural disasters.
Official Import Distributor Bigtent Outdoor
Equipment Ltd. www.bigtentoutdoors.com
info@bigtentoutdoors.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>