PDQ 6400 Motorized Latch Retraction Instruction Manual
- June 4, 2024
- PDQ
Table of Contents
PDQ 6400 Motorized Latch Retraction
CALIBRATION AND INSTALLATION INSTRUCTIONS
REMOVE FILLER PLATE
- Slide filler plate away from pushbar
- If plastic filler plug remains inside the main rail, remove and reinstall into filler plate
INSTALL EXIT DEVICE THEN CONNECT POWER
- Follow exit device template and instructions to fully install exit device without filler plate
- Terminate all MLR connections “Refer to pdqlocks.com for MLR datasheet
ENTER CALIBRATION MODE
Press and hold the calibration button Apply momentary power o i.e. swipe badge
or enter pin The unit will emit (1) short beep Release calibration button The
device is now in calibration mode
CALIBRATE PUSH BAR
Depress the push bar then apply momentarily power
The device will emit (1) long beep When the beep has finished, release the
pushbar Test latch retraction with badge/pin if calibration is not to your
liking. repeat steps 3 and 4
REINSTALL FILLER PLATE AND END CAP
- Ensure filler plate is flush with the main rail
- Reinstall end cap
MLRFIELD INSTALLAITON INSTRUCTION
- REMOVE THE EXISTING DOGGING PLATE AND REPLACE IT WITH MLR
- Remove (3) screws that are securing the dogging plate, if applicable
- Discard dogging plate
- Install MLR
- INSTALL LINK ROD
- Install link rod through link bar and through MLR bracket
- Install retaining ring on both sides
- INSTALL PUSH-N RIVET INTO FILLER PLATE
Consult customer service if you are converting from anything other than hex dogging
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>