L6OP7Lx6x Proled Opal Linotopus Installation Guide

L6OP7Lx6x Proled Opal Linotopus

Product Specifications

• Manufacturer: MBN GmbH
• Address: Balthasar-Schaller-Str. 3, 86316 Friedberg – Germany
• Website:www.proled.com
• Energy Efficiency Class: F

Product Usage Instructions

Pre-Installation Steps

1. Before starting the installation, ensure the power supply is switched off.
2. If replacing an existing light fixture, remove the appropriate circuit fuse to prevent accidental power supply activation.

Installation Process

1. Connect the Flex Strip Opal Shape to the supply cable in the bar.
2. Connect the primary side of the driver to the power supply (230VAC).
3. Ensure all connections are securely tightened with no loose strands.
4. Make sure to comply with fire regulations while fitting the lights.
5. If you have any doubts about the installation process, seek assistance from a qualified electrician.

Frequently Asked Questions

Q: What should I do if I encounter difficulties during the installation?

A: If you face any challenges or uncertainties while installing the product, it is recommended to contact a professional electrician for assistance.

Q: Can I use this product without connecting it to a power supply?

A: No, this product requires connection to a power supply for operation. Ensure proper electrical connections are made following the provided instructions.

Warning:

1. For indoor use only
2. Please ensure that the packaging is disposed of in a safe environment
3.  If a cable is defective, do not use luminaire
4. We do recommend that a qualified electrician should be used to install the products
5. Do not look at the lighted lamp directly

Safety indices

• Be sure to have a qualified electrician complete installation. The customer is not entitled to claim for any lights installed without observing European safety directives.
• The manufacturer is then discharged from liability when damage is caused by improper use or installation. If any luminaire is subsequently modified, the person responsible for the modification shall be considered as manufacturer.
• For indoor use only. Protection class IP20.

Installation

Please follow the sequence of installation step by step. Non-observance can lead to damage of LED.

1. Switch off the electricity at the mains before commencing installation or lamp change and (if a fuse box is installed) remove the appropriate circuit fuse to avoid accidental switching on of the mains supply.
2. Connect the Flex Strip Opal Shape to the supply cable in the bar.
3. Connect the primary side of the driver to the power supply (230VAC)
4. Make sure all connections are tight with no loose strands
5. Ensure fire regulations are not breached when fitting your lights
6. If you are in any doubt regarding these instructions, consult a qualified electrician

Remark to the energy efficiency class of the light source:

This product contains a light source of energy efficiency class F.

Attention:

• This product counts as a „containing product“ according to directive (EU) 2019/2020 and (EU) 2019/2015.
• The light source is part of the containing product. A separation of the light source and the containing product using commonly available tools is possible with this product.
• Replacement of the light source using commonly available tools is possible with this product.
• The light source can be separated for testing purposes.
• Installation and commissioning may only be performed by qualified persons.

Installation Instruction

MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg – Germanywww.proled.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>