PROLED L711L074 LOW BAY MINI 53 80 Light Instruction Manual

: June 3, 2024
: PROLED

Table of Contents

Characteristics:
Safety indices:
Installation:
Documents / Resources

Installation manual
PROLED LOW BAY MINI 53 / 80
L711Lxxx

Characteristics:

PHILIPS LED Warm White, Neutral White, or White
Power consumption 53 W (MINI 53) or 75 (MINI 80)
Aluminium housing anodized
Beam angle 60°
Driver 220 – 240 VAC, 50/60 Hz
Dimmable with 1 – 10 V
Operating temperature range -40° C till +55° C
CE compliant with applicable European directives
Protection class IP20

Warning:

Make sure enough load capacity (min. 10 kg) for fixing point is existing.
Please ensure that the packaging is disposed of in a safe environment.
If cable is defected, do not use the luminaire.
We do recommend that a qualified electrician should be used to install the products.
Do not look at the lighted lamp directly.

Safety indices:

Be sure to have a qualified electrician complete the installation. The customer is not entitled to claim for any lights installed without observing European safety directives. The manufacturer is then discharged from liability when damage is caused by improper use or installation. If any luminaire is subsequently modified, the person responsible for the modification shall be considered as a manufacturer. Do not cover lamps with heat-insulating materials. During usage the surface becomes hot. Please do not touch the surface until the luminaire cools down adequately. Protection class IP20.

Installation:

Please follow the sequence of installation step by step. Non-observance can lead to damage to the Luminaire.

Switch off the electricity at the mains before commencing installation or lamp change and (if a fuse box is installed) remove the appropriate circuit fuse to avoid accidental switching on of the mains supply.
Remove the luminaire and the reflector from the box.
Mount the added loop to the luminaire.
Mount the reflector to the luminiare
Install the luminaire to the hook. Take care that the hook has enough load (min. 10kg).
Connect the primary side of the driver to a power supply (230V). The luminaire must be earthed.
The luminaire is standardly dimmable with 1-10 V. If you don’t request dimming, please secure the ends of dimming cable.
Make sure all connections are tight with no loose strands.
Ensure fire regulations are not breached when fitting your lights.
If you are in any doubt regarding these instructions, consult a qualified electrician.

PROLED L711L074 LOW BAY MINI 53 80 Light-

ATTANTION:
During connecting of mains power to primary side of power supply please take care about following:
Red cable = L – wire
Blue cable = N – wire
Green or Yellow cable = Earth
Energy efficiency class of the light source:
Products listed in this manual contain a light source of efficiency class E.
ATTENTION:
Installation and commissioning may only be performed by qualified persons.
National installation regulations must be observed.
Luminiares must be disconnected from the mains before any work.

12.21 Technical amendments reserved

MBN GmbH ● Balthasar-Schaller-Str. 3 ● 86316 Friedberg ● Germany
www.proled.com

Documents / Resources

| PROLED L711L074 LOW BAY MINI 53 80 Light [pdf] Instruction Manual
L711L074, LOW BAY MINI 53 80 Light, L711L074 LOW BAY MINI 53 80 Light, BAY MINI 53 80 Light, MINI 53 80 Light, 80 Light, Light
---|---