L15 Proled Flex Strip Wall Instruction Manual

: June 3, 2024
: PROLED

Table of Contents

L15 Proled Flex Strip Wall
PROLED FLEX STRIP WALL L15xxxx
- Installation:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

L15 Proled Flex Strip Wall

PROLED FLEX STRIP WALL L15xxxx

Characteristics:

SMD 3030 CHIP Super Warm White, Warm White, Neutral White or White
Power supply 24 VDC, 18 W/m
Plastic covering, square in grey or white
Beam angle 30°, 45° or 60°
Dimmable with optional drivers
Protection class IP65 (End caps IP65 when correctly installed and glued)
Operating temperature range -10° C till +45° C
CE compliant with applicable European directives

Warning:

For indoor and outdoor use, as protection class IP65
Please ensure that the packaging is disposed of in a safe environment
Maximum 5m in one line possible
If cable is defected, do not use the luminaire
We do recommend that a qualified electrician should be used to install the products
Do not look at the lighted lamp directly

Safety indices:
Be sure to have a qualified electrician complete installation. The customer is not entitled to claim for any lights installed without observing European safety directives. The manufacturer is then discharged from liability when damage is caused by improper use or installation. If any luminaire is subsequently modified, the person responsible for the modification shall be considered as manufacturer. Do not cover lamp with heat-insulating materials. For indoor and outdoor use. Protection class IP65.

Installation:

Dimensions and length calculation at side input
L = Complete length Flex Strip Wal
L1 = Minimum section length
La = Length of Flex Strip Wall without end caps
N = Amount of sections (1, 2, 3, … , 20)
Dimensions and length calculation at bottom input
L = Complete length Flex Strip Wall
L1 = Minimum section length
La = Length of Flex Strip Wall without end caps
N = Amount of sections (1, 2, 3, … , 20)
Cutting (if needed)
ATTENTION:
Before cutting FLEX STRIP WALL please remove it from power supply. Cut only at the marking points of sections at the back side of the strip (for example 3 sections).
Fixing accessories
Connection diagram
Hints for bending Flex Strip Wall

Energy efficiency class of the light source:
Products listed in this manual contain a light source of energy efficiency class: E.

ATTENTION:
Installation and commissioning may only be performed by qualified persons.
National installation regulations must be observed.
Luminaires must be disconnected from mains before any work.

The product is a “containing product” according to directive (EU) 2019/2020 and (EU) 2019/2015.
The light source is an integral part of the containing product. Separating of light source and containing product results in irreversible damage. Exchange of the light source with commonly available tools is not useful for this product.

The installed light source can be removed for testing purpose.
The replacement of light source is not intended, as the containing product will be destroyed.