L17260x6x Proled Wall Lightn Cube Instructions
- October 27, 2023
- PROLED
Table of Contents
Installation manual
PROLED WALL LIGHTN CUBE V / X / Y
L17260x6x
Characteristics:
- LED Warm White
- Power consumption 4,5 W (CUBE V), 9 W (CUBE X), 8,5 W (CUBE Y)
- Powder coated aluminium in silvergrey or white ( similar to RAL 9003)
- Power supply 110-240 VAC, 50/60 Hz
- Operating temperature range -10° C till +45° C
- CE compliant with applicable European directives
Warning:
- Safety class IP65 (outside)
- Please ensure that the packaging is disposed of in a safe environment
- If cable is defected, do not use the luminaire
- We do recommend that a qualified electrician should be used to install the products
- Do not look at the lighted lamp directly
Safety indices:
Be sure to have a qualified electrician complete installation. The customer is not entitled to claim for any lights installed without observing European safety directives. The manufacturer is then discharged from liability when damage is caused by improper use or installation. If any luminaire is subsequently modified, the person responsible for the modification shall be considered as manufacturer.
Installation:
Please check the function of the luminaire before installation. Claims after
installation can’t be accepted.
Please follow the sequence of installation step by step. Non-observance can
lead to damage of LED.
- Switch off the electricity at the mains before commencing working at the luminaire.
- Remove fixing angle from luminaire by removing side screws.
- Drill 2 holes for fixing angle on the desired position. Use the fixing angle as template.
- Put the power line through the fixing angle und fix it on the wall.
- Connect the luminaire cable to the power line.
- Place the luminaire on the fixing angle.
- Fix the luminaire to the fixing angle with the two side screws.
- Switch on back the main power supply and test luminaire.
- If you are in any doubt regarding these instructions, consult a qualified electrician.
Connection diagramm:
Installation pictures:
ATTENTION:
This product counts as „containing product“ according to directive (EU)
2019/2020 and (EU) 2019/2015.
The light source is part of the containing product. A separation of the light
source and the containing product using commonly available tools is possible
with this product.
Replacement of the light source using commonly available tools is possible
with this product.
The light source used can be removed for testing purposes. This product
contains a light source of energy efficiency class F.
Installation and commissioning may only be performed by qualified persons.
National installation regulations must be observed.
Luminiares must be disconnected from mains before any work.
06.22 Technical amendments reserved
MBN GmbH ● Balthasar-Schaller-Str. 3 ● 86316 Friedberg ● Germany
www.proled.com