PROLED L1728Q06x Wall Light Surf Q User Manual
- October 27, 2023
- PROLED
Table of Contents
PROLED WALL LIGHT SURF Q
L1728Q06x
Installation manual
L1728Q06x Wall Light Surf Q
Characteristics
- SMD CHIP Warm White
- Power consumption 1 W
- Plastic housing square
- Housing colour White, Grey or Black
- Power supply 220-240 VAC, 50/60 Hz
- Operating temperature range -10° C till +45° C
- CE compliant with applicable European directives
Warning:
- Safety class IP65 (outside)
- Please ensure that the packaging is disposed of in a safe environment
- If cable is defected, do not use the luminaire
- We do recommend that a qualified electrician should be used to install the products
- Do not look at the lighted lamp directly
Safety indices
Be sure to have a qualified electrician complete installation. The customer is not entitled to claim for any lights installed without observing European safety directives. The manufacturer is then discharged from liability when damage is caused by improper use or installation. If any luminaire is subsequently modified, the person responsible for the modification shall be considered as manufacturer.
Installation
Please follow the sequence of installation step by step. Non-observance can lead to damage of LED.
- Switch off the electricity at the mains before commencing installation or lamp change and (if a fuse box is installed) remove the appropriate circuit fuse to avoid accidental switching on of the mains supply.
- Gently take off the front cover.
- Remove 4 screws and take away the Plexiglas cover. Please retain 4 screws for re-use.
- Insert the power supply (230 VAC) through rubber grommet.
- Place the luminaire on desired position. Make sure not to damage wires during installation. Mark the fixing holes. Use the wall plate as a template. Place the wall plate in level. Use appropriate fixings to secure the back plate to the wall.
- Connect the mains supply to the terminal block. This is a safety class 2 luminaire and must not be earthed. If you have any earth cable, you can’t connect it to terminal block. Make an sufficient isolation on the earth vain.
- Place the Plexiglas cover back on wall plate and secure with 4 screws. Make sure no cables are trapped or damaged.
- Push the front cover back onto luminaire.
- Switch on back the main power supply and test luminaire.
- Ensure fire regulations are not breached when fitting your lights
- If you are in any doubt regarding these instructions, consult a qualified electrician
REMARK TO ENERGY EFFICIENCY CLASS:
This product contains a light source of energy efficiency class E.
ATTENTION:
Installation and commissioning may only be performed by qualified persons.
National installation regulations must be observed.
Luminiares must be disconnected from mains before any work. Power supply can
not be changed in the luminaire.
MBN GmbH
Balthasar-Schaller-Str. 3
86316 Friedberg
Germany
www.proled.com
Documents / Resources
|
PROLED L1728Q06x Wall Light Surf
Q
[pdf] User Manual
L1728Q06x Wall Light Surf Q, L1728Q06x, Wall Light Surf Q, Light Surf Q, Surf
Q
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>