NINGBO SP0643 UL Listed 5000 mAh 15W MagClick Power Bank and iWatch Charger Instruction Manual

UL Listed 5000 mAh 15W
MagClick™ Power Bank and
iWatch Charger
Instruction manual
7122-18 Model #: SP0643

Functions:

1. Wireless/iWatch charger power button
2. Type-C Input
3. Type-C Cable Input/Output
4. Power display
5. Wireless charging surface
6. iWatch charging surface
7. Bracket

What’s included:
1 x Wireless Power Bank
1 x Instruction Manual

Tech Specifitions

• Type-C Input: 5Vdc/2.1A, 9Vdc/2A, 12Vdc/1.5A

• Cable Input: 5Vdc/3A, 9Vdc/2A, 12Vdc/1.5A

• Cable Output: 5Vdc/2.1A, 9Vdc/2A, 12Vdc/1.5A

• Wireless Output: 5W/7.5W/10W/15W

• iWatch Output: 2W Max

• Battery/Cell Capacity: 18.5Wh, 3.7V/5000mAh

• Product Capacity(Cable Output): 13Wh,
  5Vdc/2600mAh

• Operating temperature: 5~40°C tor Charging
  0~40°C for Discharging

Instructions:

1. Charging the Power Bank:
   Insert the type-C tip of the cable into a certified
   AC adapter and the other end into the type-C
   Input port (2) to begin charging, or use Type-C cable (3) to connect a certified AC adapter to begin charging. The Power display will show the percentage of capacity when the device is charging.

2. Cable Charging Your Mobile Device:
   Use Type-C cable (3) to connect your mobile device directly. It will charge your mobile device automatically. Once fully charged, remove the device.

3. Wireless Charging Devices:
   Place your wireless charging device/iWatch on the wireless charging surface (5)/iWatch chargingsurface (6). Press the power button (1) once, the device/iWatch will begin to charging immediately.
   Once fully charged, remove the device/iWatch.

SAFETY PRECAUTIONS:

• WARNING-When using this product, basic precautions should always be followed:

1. Read all the instructions before use.
2. Never store or use this product in temperatures below 32°F(0°C) or above 113°F (45°C).
3. Do not overcharge your phone. The unit may become hot under excessive use. Remove your phone once it is fully charged. Never charge your phone for more than 7 hours ata time.
4. To reduce the risk of injury, close supervision is required when the product is used near children.
5. Do not expose the device to moisture.
6. Do not use the device in excess of its output rating. Overload outputs above the rating may result in a risk of fire or injury
7. Do not use the device if damaged or modified.
8. Damaged or modified batteries may exhibit unpredictable behaviour resulting in fire, explosion or risk of injury.
9. Do not disassemble the device. For repairs, seek a qualified service professional. incorrect reassembly may result in a risk of fire or injury.
10. Do not expose the device to fire or excessive temperature. Exposure to fire or temperatures above 104°F may cause explosion.
11. To ensure product safety, ensure that identical replacement parts.
12. Attachments on the back of your phone can impede the effectiveness of the wireless charger, and lead to overheating. You must remove attachments from the phone before charging on this device.

FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

• Warning:
  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
  Note :
  This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This  quipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
IC Statement :

• This device contains licence-exempt transmitter (s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Radio Frequency Exposure Statement for IC This equipment complies with IC exposure limits set forth for an uncontrolled environment.
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
CAUTION: Risk of Fire and Bums, don’t open, crush, disassemble and dispose of in fire.
Accessible surfaces held or touched for short periods only. Don’t heat above 45 °C or Incinerate. Follow Manufacturer’s Instructions

Name of the Distributor:
Leedsword Inc
Address of the Distributor:
400 Hunt Valley Road,
New Kensington,
PA 15068 USA.
WWW.PCNA.COM
FCC ID:2BCGV0016
IC: 31955-00005
HVIN:005
Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>