NINGBO Q92BH23A Remote Control Transmitter Instructions
- September 16, 2024
- Ningbo
Table of Contents
Q92BH23A Remote Control Transmitter
“`html
Product Information
Specifications:
- Transmission Frequency: 433.92MHz
- Remote Control Distance: 100 feet (free area)
- Power for Transmitter: CR2032 3V Battery
Product Usage Instructions
Step 1: Installing the Battery
Open the transmitter casing and insert a CR2032 3V battery into
the corresponding socket accordingly.
Step 2: Operating the Transmitter
To use the transmitter, ensure it is within the specified remote
control distance of 100 feet in a free area. Press the appropriate
buttons to send signals to the paired receiver.
Step 3: FCC Compliance
Ensure that the device complies with Part 15 of the FCC rules.
The operation is subject to conditions where the device should not
cause harmful interference and must accept any interference
received.
Any changes or modifications not approved by the responsible
party for compliance may void your authority to operate the
equipment.
FCC Radiation Exposure Statement: The equipment complies with
FCC radiation exposure limits for an uncontrolled environment.
FAQ
Q: What should I do if the transmitter is not working?
A: Check if the battery is properly inserted and has power.
Ensure that you are within the specified remote control distance
and there are no obstructions blocking the signal.
Q: How can I pair the transmitter with a receiver?
A: Refer to the receiver’s manual for instructions on pairing
with the transmitter. Usually, there is a specific process
involving button presses or settings to establish the
connection.
“`
Transmitter instruction
Technical data: Transmission frequency Remote control distance Power for transmitter
433.92MHz 100feet(free area) CR2032 3Vbattery
Installation: ·Install 1pc CR2032 3V battery in the transmitter’s battery
compartment,
making sure the polarity+/-of the battery is correct. ·Plug each socket into a
power socket and plug a device into each
socket. ·Push each ON or OFF button on transmitter will turn on or off the
corresponding socket accordingly.
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does 03cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>