YiFeng M26 2 In 1 Magnetic Wireless Charging Stand User Manual
- August 7, 2024
- YiFeng
Table of Contents
2-in-1 Magnetic
Wireless Charging Stand
Model: M26 User Manual
M26 2 In 1 Magnetic Wireless Charging Stand
Thank you for choosing the 2 in 1 Magnetic Wireless Charging Station.
Please read this user manual carefully before use and keep this manual in a
safe place for future reference.
Please purchase QC3.0 18W or above adapter to use together
Specifications
- 2 in 1 Magnetic Wireless Charging Stand
- lnput: 9V 2.66A/12V 2A
- Phone output: 15W Max
- Earphone output: 5W Max
- USB-C interface
Folding tips
Can charge mobile phones or headphones
Can charge headphones or mobile phones
Compatible Devices
- (Magnetic)iPhone 15 Pro Max/15 Pro/15 Plus/15/14 Pro Max/14 Pro/ 14 Plus/14/13 Pro Max/13 Pro/13/13 mini/12 Pro Max/12 Pro/12/12 mini AirPods Pro 2/AirPods 3/AirPods Pro/AirPods 2.Compatible with other wireless charging phones that support QI protocol Please use a magnetic case to charge your phone
Please Note:
- Only use certified QC 3.0/PD Charging Wall Adapter to charge the device, do not plug into computer USB port or any other non-certified USB port.
- Place your Qi-enabled device accurately in the wireless charging area when charging.
- a QC 3.0/PD adapter is required when charging mobile phones can be quickly charged
- Make sure to disconnect the device from power when cleaning.
- lt is normal and safe to hear a humming noise when very close to the charger. lt means that this wireless charger is adjusting its temperature to achieve a more efficient charging speed.
- If your device can not be fully charged, this may due to high environmental temperature, please recharge after the temperature is lowered. Our charger has temperature control to safeguard your device when charging.
Important Safety Instructions
- Do not store device in high-temperature environment, including heat caused by intense sunlight or other forms of heat.
- Do not place device in fire or other excessively hot environments. Exposure to fire or temperature above 212°F(100C) may cause explosion.
- Do not use the wireless charger in excess of its output rating. Over loading outputs above rating may result in a risk of fire or injury to persons.
- Do not expose the wireless charger to rain or snow.
- Do not modify, repair or disassemble the unity, if so, please contact the manufacturer. Switch off the wireless charger when not in use. The wireless charger will automatically switch off when disconnected from its wall charger.
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance between 20cm the radiator your body
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>