Shenzhen Yifeng Intelligent Technology T6 3 in 1 Wireless Charging Dock User Guide
- June 6, 2024
- Shenzhen Yifeng Intelligent Technology
Table of Contents
3 in 1 Wireless Charging Dock
Model: T6
Users Guide
Product overview
Place the watch on the corresponding charging area, the watch enters the state of wireless charging. the white light will turn on for 20 seconds then off.
Place the mobile phone on the corresponding charging area, and the mobile
phone will enter the state of wireless charging. the blue light will turn on
for 20 seconds then off.
Place the TWS heads on the corresponding charging area, and the headset will
enter the state of wireless charging, the green light will turn on for 20
seconds then off.
Specifications
Product name | 3 in 1 Wireless Charging Dock |
---|---|
Input Current | 9V-2A 12V-2A |
Output Current | Top:3W MAX |
Front:15W MAX
Back: MAX 5W MAX
Interface| TYPE-C
Certficate| QI, CE , FCC, RoHS
Unit Dimension| 120 x 76 x 147mm
Unit N.W.| 235g
Package Dimension| 162x123x80mnn
Package G.W.| 309g
Color| Black, White
Using instructions:
- When the product is powered on, the white light, blue light and green light will flash once and then turn off to enter the standby state.
- Place the mobile phone on the corresponding charging area, and the mobile phone will enter the state of wireless charging,the blue light will turn on for 20 seconds then off.
- Place the TWS headset on the corresponding charging area, and the headset will enter the state of wireless charging, the green light will turn on for 20 seconds then off.
- Place the watch on the corresponding charging area. and the watch enters the state of wireless charging, the white light will turn on for 20 seconds then off.
- When fully charged or need to stop charging, simply remove the device.
Attention
- Use indoor or under dry environment, avoid placing or using in the environment of high temperature, humidity, strong static electricity, and strong magnetic field.
- For your safety, please do not use wet hand plugs and unplug electrical appliances.
- Avoid putting it in a place easily accessible to infants and children.
- Do not use the product if it is contaminated with water or dirt.
- Non-professional personnel is not allowed to open and repair without authorization.
Package contents:
Wireless charger…………….. 1
Cable …………………………1
User manual ………………….*1
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
RF warning for WPT device:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of the device, a distance of
15cm surrounding the device and 20 cm above the top surface of the device must
be respected.