NINGBO RSL366T RSL Wireless Remote Control Instruction Manual
- August 6, 2024
- Ningbo
Table of Contents
NINGBO RSL366T RSL Wireless Remote Control
Operating elements
- Indicator lamp
- Control keys
- Sliding key
- Battery compartment lid
Inserting/replacing battery
- Remove the battery compartment lid (4) from the back of the remote control.
- Insert one round cell battery, type 12V/23A, into the battery recess. The positive pole should face upward (see the “+” imprint on the battery). Push the battery all the way into the battery recess.
- Close the battery compartment. The battery must be replaced when the remote control’s range decreases noticeably or when the indicator lamp (1) no longer lights when a button is pushed.
Key functions
- The control keys (2) are arranged in two columns: left column = ON/ right column = OFF.
- Use the upper four keys on the left column to activate channels 1 to 4 individually.
- Use the upper four keys on the right column to deactivate channels 1 to 4 individually.
- The indicator lamp (1) lights up each time a key is pressed.
Operation
Configuration and the dimming function will depend on your radio-controlled
power outlet. You can find detailed information in the operating instructions
of your radio-controlled power outlet.
The remote control can control an unlimited number of compatible radio-
controlled power outlets
Technical data
Battery type …………………………12V/23A
Number of channels ……………..4 codes+ 4 channels
Transmission frequency…………433.92 MHz
Transmission range ………………max. 30 m (in open area)
Notice
- Do not ingest battery, Chemical Burn Hazard
- This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
- Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This device generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The device can be used in 0mm exposure condition, compliance with exposure
requirements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>