NINGBO 2AM3B-CM-MRC Electric Winch Wireless Controller Instructions

: July 26, 2024
: Ningbo

Table of Contents

Features Overview
Installation and function
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Electric winch wireless controller
instructions

Features Overview

This wireless remote control firing frequency of 315MHz, the control range of more than 25 m, used in electric winch wireless control.
The wireless remote control parameters

Working voltage: DC12V, 23A battery.
The working current: 25mA ± 5mA
Transmitting frequency: 315MHz
The transmit power: <10dBm
Standby current: <5uA

Using
The remote controler has 2 buttons. Press and hold on the remote control “OUT” or “IN” button, it will trigger 315MHz high frequency. The high-frequency signal emitted by the antenna to control receiver unit.

Installation and function

Disconnect Power to the winch
Confirm that the plug is the correct type for this winch and plug it in
Select an area for the receiver on the vehicle close enough to the winch to allow cable connection
Investigate the chosen area to make sure no components will be damaged by installation.
Permanently (optional) mount the remote control receiver to the vehicle using appropriate hardware (not included).
Preare the winch for operation as explained in its manual
Reconnect winch’s power
Release the clutch handle and pull out about 10 feet of wire rope Leave the wire rope laying on the ground and stay clear of the wire rope and hook
Reengage the clutch handle
Watch the spool and wire rope and briefly,press the out button on the remote control to verify that the cable feeds out
WARNING! If the cable does not feed out ,check and correct the winch’s wiring. Retest after correction.
Watch the spool and wire rope and briefly press the in button on the remote control to verify that the cable retracts WARNING! If the cable does not feed out ,check and correct the winch’s wiring .Retest BOTH functions after correction.
If the remote operates the winch properly, it is ready for use.
After use, disconnect control box from winch to prevent accidental operation

Wiring diagram WARNING!
To prevent serious injury

Disconnect control box from winch before service and after every use.
WINCH CAN OPERATE SUDDENLY AT ANY TIME WHILE CONNECTED.
Stand clear of winch, fairlead, and wire rope while connected. Keep bystanders away.
Only operate controls when winch and entire wire rope is within view.
Use with vehicle mounted recovery winches only. Do not use for any other application.
Confirm control box mounting location has no wire or components that can be damaged drilling.
Read winch manual before use.

FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.