Maxxima MRL-S412105 Trimless Gimbal Down Light Instructions
- July 23, 2024
- Maxxima
Table of Contents
4″ Trimless Gimbal Downlight Installation Guide
MRL-S412105
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unable about the installation or the maintenance of the fixture, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical components.
CAUTIONS
- The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
- Supply conductors must at least be rated for 90°C/194°F.
- This fixture is designed for use with 120 VAC, 50/60 Hz only.
- Suitable for damp locations.
INSTALLATION INSTRUCTIONS
1. Ensure the power has been turned off by switching the circuit breaker to
the off position or by removing the fuse from the fuse panel.
2. After marking the center point of where the fixture will be located, using
the provided template cut the required hole shown in figure 1.
Figure 1
3. Install the plaster frame into the new cutout and use the four screws provided, secure hte frame to the ceiling shown in figure 2.
Figure 2
4. Plaster over the plaster frame ensuring not to apply too much plaster to fill beyond the raised rim shown in figure 3.
Figure 3
5. Using the CCT switch on the junction box, preview and select the desired
color temperature.
6. Open the junction box, remove the desired knockout and attach a twin clamp
connector (not provided or necessary).
7. Insert the supply wire through the twin clamp or the knockout.
8. Connect the hot (black) wire to the black supply wire, the neutral (white)
wire to the white supply wire, and the ground (green/bare copper) wire to the
green using the supplied wire nuts shown in figure 4.
Figure 4
9. Put all wires into the metal junction box and close the box.
10. Insert the junction box into the plaster frame, ensuring the junction box
is laying on the ceiling material. Then align the locking tabs on the side of
the fixture so the fixture can be inserted into the frame, rotate the fixture
until it is locked in place.
11. Installation is now complete. Restore power, the fixture is now
operational.
Twist
Figure 5
Figure 6
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
info@maxximastyle.com 866-MAXXIMA (629-9462)
www.maxximastyle.com 125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>