Dgl Group CoCa Cola Wireless Stereo Speaker User Guide
- June 6, 2024
- DGL GROUP
Table of Contents
WIRELESS STEREO SPEAKER
QUICKSTART GUIDE
Charge the speaker before using it for the first time.
EASY PAIRING (first time pairing)
Make sure the speaker is turned on before attempting to pair it with a smart
phone or tablet
Your speaker will automatically enter pairing mode.
Blue LED indicator, will start flashing. The speaker will ” beep” when it is
ready to connect.
From your smart phone or tablet, find a list of nearby devices and choose “CC-
BTCN”. Enter “0000” if asked. The blue indicator will turn solid blue when
pairing is complete! You will also hear” beep ”
Now you can play your favorite music.
PAIRING YOUR SPEAKER
Your speaker will work best if it is within 30 ft of your smart device. You may experience sound briefly cutting off if you are out of range or if your wireless connection is weak. Make sure Bluetooth is enabled on your smart phone or tablet before starting the pairing process.
SPECIFICATIONS
Bluetooth Version:
Speaker
Operation Range:
Play Time:
Battery Capacity:
Frequency response:
Signal Noise Ratio:
Charging Time:
FCC ID:
BT ID:| 51
3W
Up to 33ft (10m)
Up to 3 hours
300mAh
100HZ-18KHZ
≥ 85dB
Up to 2 Hours
2AANZBTCN
D042258
---|---
WARRANTY
Contact us if you have any problems at support@dglusa.com.
WARNING
Keep away from water and moisture.
Keep away from heat sources.
Do not disassemble.
MEDIA KEY FUNCTIONS
On/Off Switch • Turn left/right to turn on/off device
Next/Vol+ • Turn left – next track • Hold left – Volume up
Prev/Vol- • Turn right – previous track • Hold right- Volume down
Play/Pause • Press – to play/pause music • Press and hold – change to
different reproduction modes
USB Port
Listen to your music stored on a flash drive. Music will play once the flash
drive is inserted into the USB port.
Micro SD
Insert the TF card into TF slot. Music will play once the card is inserted.
Auto Reconnect
If the speaker is off, while connected to the phone, it will reconnect when
the speaker is turned back on and in range.
AUX Mode
To play music in AUX mode, connect the USB cable (included) to the speaker.
The speaker will function as a sound amplifier.
Charging
Connect the USB cable (included) into the USB port on the speaker. Red light
indicates speaker is charging.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>