ET2 E21566-142BK 10 Light LED Linear Pendant Instruction Manual
- July 15, 2024
- ET2
Table of Contents
ET2 E21566-142BK 10 Light LED Linear Pendant Instruction Manual
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a box knife, be careful not
to damage the components inside,
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to install it.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product
Risk of suffocation!
Keep packaging materials away from children.
Lamp Care Instructions
Carefully read through the instruction sheet before assembly and using the product
Caution there is a risk of shock!
Disconnect from power source before assembling or cleaning.
Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it
could cause fire.
Check the product cord to be sure is free torn or frayed.
WARNING : Wires must to be connected to low voltage driver and should not
be connected directly to live wire or a short may occur.
Cleaning & Maintenance
On polished finishes, often using talc powder can reduce the appearance of
fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, Le. glass
cleaner, stone polish, & wood polish.
Clean with soft cloth and a mild detergent. Do not use abrasive or harsh
cleaners.
Periodically (every 90-180 days) make sure that the screws are fully
tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade
PARTS
Before getting, started, ensure the package contains the following components
A| | x1| B| | x1| C| | x4
---|---|---|---|---|---|---|---|---
D| | x2| E| | x4| F| | x3
G| | x1| H|
EGLS21561-142
| x10| I| | x2
J| | x2| | | | | |
-
This fixture is equipped with an LED driver, please refer to the Wiring Diagram for more details
-
This fixture is equipped with an LED driver, please refer to the Wiring Diagram for more details
IMPROPER WIRING and/or INCORRECT DIMMER use can cause CATASTROPHIC
DAMAGE!
THIS FIXTURE MUST BE INSTALLED with a COMPATIBLE DIMMER SWITCH
DO NOT CUT FACTORY-MADE CONNECTIONS
**AC:120-277V~50/60HZ
LED DRIVER DIAGRAM
**
GENERAL COMPATIBILITY
TRIAC / FORWARD PHASE
ELV/ REVERSE PHASE
Only at 120VAC
Due to inrush current, wattage should not exceed 150W on a 600W dimmer
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>