OPTIMUM OP-TIP750 24 Hour Plug in Time Switch Instruction Manual
- July 10, 2024
- optimum
Table of Contents
OPTIMUM OP-TIP750 24 Hour Plug in Time Switch
Specifications
- Voltage: 220-240V AC 50Hz
- Temperature rating: T45
- Switch type : 13A mains switching
- Rating: Max 13A resistive
- Not suitable for direct switching of lighting types: HID, SON, LED – use a contactor
- Class II control / Protection class IP20
- Complies with European Norm EN 60730-1 : 2011 Automatic Electrical Controls for Household and similar use
- Complies with European Directives: LVD; EMC; RoHS
Product Usage Instructions
Instructions:
Current time aligned with the marker. Set on/off times before plugging in
the appliance.
Setting Up:
The outer dial should be set to the current time. Rotate the dial slowly in
a clockwise direction until the correct hour is aligned with the arrow printed
on the dial. Note that the outer dial is printed with the 24-hour clock (8:00
a.m. = 8 on the dial, 8:00 p.m. = 20 on the dial).
Important: Do not attempt to rotate the dial in an anti-clockwise
direction as this will damage the timer.
Programming Switching Times:
Example: Set a 6 am – 8 am On Period.
Example On / Off Period:
Provide an example of how to set an on/off period for better understanding.
Manual Switching Positions:
The device has two switching positions: TIMED OPERATION and FIXED ON.
Follow the instructions to switch between these modes as needed.
FAQ
-
Can this timer be used with LED lighting?
No, this timer is not suitable for direct switching of LED lighting types. It is recommended to use a contactor for LED lights. -
Where can I find further support or information about this product?
For additional support or information, visit www.tfc- group.co.uk or contact TFC Group at Tonbridge TN9 1TB.
Instructions
Setting up
The outer dial should be set to the current time. Rotate the dial slowly in a
clockwise direction, until the correct hour is aligned with the arrow printed
on the dial.
Note that the outer dial is printed with the 24 hour Clock
- 8:00a.m. = 8 on the dial.
- 8:00p.m. = 20 on the dial.
Do not attempt to rotate the dial in an anti-clockwise direction as this will damage the timer.
Programming switching times
Set all tappets between the on and off times required, to the outer edge of the dial (see figure 1). E.g. to set on at 8:00 a.m. – Off at 1:00 p.m., push tappets between dial numbers 8 and 13 to outer edge of dial. Set any other required switching times in a similar manner.
Example on / off period
Manual switching Positions
Specification
- Voltage: 220-240V AC 50Hz
- Temperature rating: T45
- Switch type: 13A mains switching
- Rating:
- Max 13A resistive
- Not suitable for direct switching of lighting
- types: HID, SON, LED—use a contactor
- Class II control / Protection class IP20 Complies with European Norm
- EN 60730-1: 2011
- Automatic Electrical Controls for Household and similar use, and European Directives: