Book-Nook Nebula Restroom Instruction Manual

Book-Nook Nebula Restroom

• book-nook.fr
• book-nook-kit.de
• pok-no BOOK NOOK KIT

Safety Warning

• For your safety, please read this manual before starting.
• This product is suitable for people over the age of 14, children should be under the supervision i
• Any unauthorized modification or alteration of this product will damage your rights and interests related to this product

Cautions

• The breaking points can be smoothed out with a file.
• Do not detach all the parts at the same time.
• Glue is needed in some places. After gluing, leave the product intact for two hours to ensure a strong bond
• To save time, you can first do the gluing step, then assemble the rest.
• If the part to be fitted is too tight, you can file it a little before assembling; if the installation is too I loose, you can use glue to adjust during assembly.
• Children must be accompanied by an adult during assembly.
• Please keen this manual for future reference.

Maintenance

• Do not place the product near heat or water.
• Use a soft cloth to clean the product.
• Do not use chemical products to clean the product, such as glass cleaners, solvents, alcohol ammonia, or abrasives.
• damaged, You Can contact customer supporpieces are missing or at service.booknook@gmail.com

Notes: Thank you for your purchase. If any pieces are missing or damaged, you can contact customer support at service.booknook@gmail.com

Accessoires

Wood Block List

• Attention
• Handle Accessories Carefully

INSTALLATION STEPS

STEP 1

•  LEDS Before assembling, please check the LED lights can work properly.

As shown in the image, before starting to assemble, please use the batteries to test whether the light’s power supply unit can work properly. The testing method is as follows:

1. Connect the wire port of the LED light and the wire port of the touch sensor panel to the corresponding port of the battery compartment;
2. Insert two AAA batteries;
3. Touch the touch sensor panel
4. . If the light works, it means there is no problem with the light’s power supply unit; if the light does not work properly. please contact customer service for a replacement

STEP 2

•  This tool can help you take out

• Please note the direction of F26

• Bend the light wire as shown

• Please note the direction of J12

• Touch Sensor cable

• First put E16 on the A plate, then E14 through E15

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>