LOVE KARAOKE LKM15A-PRO Portable Microphone Owner’s Manual
- June 15, 2024
- LOVE KARAOKE
Table of Contents
LOVE KARAOKE LKM15A-PRO Portable Microphone
Product Information
- Model: LKM15A-PRO
- Product Name: Speaker drivers
- Microphone Frequency Range: 521.0-532.7 MHz
- Speaker Impedance: 4 ohm
- Rated Output Power: 80 W RMS
- Signal-to-Noise (S/N) Ratio: 85 dBA
- Frequency Response: 45 Hz – 18 KHz (-6dB)
Product Usage Instructions
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Class B Digital Device
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
Warning: Changes or modifications to this unit not expressly approved by
the part responsible for compliance could void the user’s authority to operate
the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
FAQ (Frequently Asked Questions)
-
Q: What is the frequency range of the microphone in the LKM15A-PRO?
A: The microphone frequency range is 521.0-532.7 MHz. -
Q: What is the rated output power of the LKM15A-PRO?
A: The rated output power is 80 W RMS. -
Q: What is the impedance of the speaker drivers?
A: The speaker drivers have an impedance of 4 ohm. -
Q: What is the frequency response of the LKM15A-PRO?
A: The frequency response is 45 Hz – 18 KHz (-6dB).
Model : LKM15A-PRO
INSTRUCTION
- Insert the battery to the wireless microphone and make sure the polarity is correct.
- Long press to turn on the microphone, and long press again to turn off the microphone
- Adjust the microphone volume knob on the speaker to the proper volume.
- Ensure wireless microphones are operated within the speaker’s effective distance at 15m.
- Keep 5-15cm distances between the microphone and lips for best performance.
- When the power level is low, please replace it with a new battery.
- Only use the included wireless microphone in the speaker package
FEATURES
Product name | LKM15A-PRO |
---|---|
Speaker drivers | Woofer1 + 1 tweeter1 |
Microphone frequency range | 521.0-532.7 MHz |
Speaker impedance | 4 ohm |
Rated output power | 80 W RMS |
Signal-to-noise (S/N) ratio
| ****
85 dBA
Frequency response| 45 Hz – 18 KHz (-6dB)
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning : Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
- The device has been evaluated to meet general RF exposure requirement.
- The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>