BEZIOR M20 20-Inch Wheel Foldable Electric Moped Bicycle Instruction Manual

BEZIOR M20 20-Inch Wheel Foldable Electric Moped Bicycle

importing warning

• This manual includes important safety performance information and service information. Please make sure you have read the following warning content before the first time you use our product.

• If you borrow your electric bicycle to other people, please let the user read this manual, it could help to decrease the risk of accident.

• Please wear a suitable and safe helmet before riding, please wear the clothes with fluorescent and reflective stripes when you ride at night. Don’t exceed speed limit, it is a main reason of traffic accidents, we should abide by the traffic rule, we shouldn’t exceed the speed limit.

• Don’t touch the charging hole on the bike, or use metal to touch it, otherwise,the accident will be caused by the transient short circuit of the current.

• Zero starting, braking frequent, driving against the wind, carrying people or anything, insufficient air pressure on the tires. All of these will use much electric energy, and then reduce the endurance mileage. If you want the best endurance mileage, please do something as follows:

  1. please use assist mode.
     on the premise of safety, don’t break

  2. frequently or use zero starts.

  3. Don’t overload.

  4. Before riding, please check the pressure of
     the tire, and supply enough pressure.

• Our Ebike should avoid prolonged exposure to the sun or rain , avoid storage in places with high temperature or corrosive gas, so as to avoid electroplating parts and paint surface by chemical corrosion and electrical parts damage, resulting in operational failure and accidents

• Your current insurance business may not cover the situation you may encounter when riding a electric bike, please contact your insurance company or insurance broker for relevant consultation

• According to the law in China, riding an electric bicycle or a three-wheeled Electric bike must reach the age of 16. If you use this product in other countries, please refer to the local laws and regulations.

• Bicycles are vehicles with certain risk fact factor, please be sure to abide by the traffic rules. At the same time, when emergency braking , brake the rear wheel first, then brake the front wheel, when cycling speed is too fast. There is a danger of tipping over if you brake the front wheel suddenly, please ride carefully.

Product components

1. SADDLE
2. SEAT POST
3. REAR CARRIER
4. FRONT/ REAR FENDER
5. MOTOR
6. BATTERY
7. FOLDER
8. CRANKSET
9. PEDAL
10. CHAIN
11. DISPLAY
12. VERTICAL
13. HANDLE STEM
14. HANDLE STEM
15. DISC BRAKE
16. TIRE
17. KICKSTAND
18. FRONT LIGHT

Folding Method of Product

1. Adjust the saddle tube and crank, and loosen the saddle tube clamp with quick release. Insert the saddle tube down to the bottom and lock the saddle tube clamp with quick release. Adjust the crank Angle to 9 o ‘clock and fold the pedals at the same time.
2. Folding frame. Open the frame folding with a safety clasp. Fold tne left and right sides of the frame.
3. 0pen the folder of the frame, make the front wheel fold nearly parallel to the rear wheel and finish the folding of the bike.

Method of Product assembly

Tools preparation

1. Tools
2. Manual
3. Charger

Packing list (All gifts styles and colors are sent randomly and cannot be used as the reason for return)

Adjust Handlebar and standpipes

1. 0pen the folder of standpipe
2. 0pen the folder of standpipe
3. When installing stem, make sure handlebars are properly aligned and tightened
4. Fold.the handlebars and perpendicular to the ground
5. 0pen the folder of the handlebar and adjust the handlebar
6. After adjusting the handle, lock the lo Ider and then finish install of handlebar

Mounting pedal

1. This bike provides convenient accessories, please Check the L and R marks on the pedals.
2. Take wrench from toolbox
3. R means it should be installed in the right side, and L means it should be installed on left side
4. R means it should be installed on the right side,L means it should be installed in the left side

Adjust saddle and seat tube

1. Push the saddle down
2. 0pen the folder of the seat tube
3. Adjust and rotate the seat
4. Finally, Lock the folder

The method of removing the battery

( The battery of the Standard version can t be removed )

1. Open the folder
2. Loosen the folder
3. insert the key to battery lock
4. Remove the battery

Product instruction

Charging method (First is the standard version .Second is the the high- end version)
Picture 1

1. Take out the battery charger
2. The charger hole is on the left side of the frame and near the folder
3. Plug the charger into power supply
4. Red Light shows the battery is charging, green light is full

Picture 2 (Charging method of electric bikes with removable batteries) Suitable for High end version

1. Take out the battery charger
2. You can take battery to your company or home to charge it
3. Plug one end of the charger into the battery (Red )and the other end (Blúe,) into the power supply.
4. Red Light shows the battery is charging, green light is full

Power switch < functional instruction)

• Turn on the power clockwise
  (Blue arrows)

• Turn off power counterclockwise
  (Red arrows)

• Start riding and turn on the handle
  (Green arrows) is the electric mode; when riding the bicycle, it automatically turns on the
  power-assisted mode; when the power 1s turned off, it is the human-powered cycling mode.

• Turn on the power clockwise
  (Blue arrows)

• Turn off power counterclockwise
  (Red arrows)

• Start riding and turn on the handle
  (Green arrows) is the electric model. The LCD display shows the power(Yellow ) and riding speed(Blue).

Notes

1. Before riding, please read the «User’s Manual)) carefully. Please check whether the parts are in good condition to ensure the safety of your riding.
2. Please check the status of the vehicle. Please check the brake, wheel, handlebar, folding buckle, and quick release part of the electric bike to make sure the electric bike has good status.
3. Please check the electrical system: To know whether the battery power is enough. if it is not enough, you need to charge it as soon as possible.
4. Please check whether the brake_system works properly. If it doesn’t work properly, please stop using it, and please contact the official customer service person.
5. insert the standpipe at a depth not less than the minimum depth (with the safety line as the minimum depth). See figure 2
6. The height of the saddle tube can be adjusted according to personal preference, but the insertion depth shall not be lower than the minimum insertion depth (with the safety line as the minimum depth) to ensure safety and lock it.
7. lnstall pedals: if you buy new products. you need to install pedals by yourself. The pedals are divided into left and right sides. The “R” means the Right pedal. the “L means the Left pedal. and then tighten them counterclockwise. Remember it should be counterclockwise. See figure 3 and 4

Warranty policy

1. Users should operate in accordance with the product manual. In case of any performance fault caused by the production quality, the company shall perform the obligations of the three guarantees in accordance with the provisions of relevant laws and regulations of the state.
2. The company is still responsible for the after-sales service of the faults beyond three guarantees and the major components in the Three guarantees, but there will be a cost for repair.
3. The battery replacement over the warranty time, Our
   company will be supply the battery by factory price. To ensure safety and not to pollute the environment
   the battery must be 1: 1 recycling and returned to the battery manufacturer.

Address: 12 Floor, Building NO. 12, Hua Yao Cheng, Fu An Avenue, Ping Hu, Long Gang District, Shenzhen
MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>