BELL Lighting 11370V2 Firestay CCT LED Down Lights Installation Guide
- July 8, 2024
- BELL lighting
Table of Contents
BELL Lighting 11370V2 Firestay CCT LED Down Lights
Important Information
We recommend that luminaires are installed by a qualified electrician ensuring the installation complies with current IEE wiring regulations BS7671:2018 & local building control.
- All tests should be carried out in accordance with EN 50172:2004.
- BELL will not accept responsibility for any claims arising from a poor installation.
- The light source of this luminaire is not replaceable: when the light source reaches the end of life, the whole luminaire must be replaced
Important User Advice
- The ambient room temperature should not exceed 30°C.
- Always switch off the mains supply before installing.
Table 1
- Downlight
- 11370V2
- Cut Out Ø
- 68-70mm
Read these instructions before installation and retain them for future reference This equipment should be installed by a competent electrician
Installation
- Cut a suitable diameter hole in the ceiling for your downlight (see Table 1) ensuring that it does not infringe with electrical cables, water/gas pipes, or ceiling joists, (see Fig 1).
- Remove bezel and adjust to the required colour temperature and wattage, (see Fig 2).
- Wire the female connector (separate in the package) to the circuit, and make the necessary circuit tests. Connect the male connector (the one which is connected to the lamp) to the female connector, ensuring that they are fully ‘Clicked’, (see Fig 3).
- Fold spring clips upwards and insert fitting into the hole, (see Fig 4).
- Release spring clips to hole fitting in place, (see Fig 5).
- Test for correct operation.
Firestay CCT downlights have a choice of four color temperatures(2700k, 3000k, 4000k, 6000k). Also a choice of two wattages(4W/6W). You can choose the color temperature and wattage you prefer via the switches under the bezel. To change bezels simply twist and lock the bezel on the fitting, (see Fig 6).
Insulation Coverable (IC Rated)
The lamp is designed for use with insulation material so that it does not need
extra IC cage accessories.
- L: Live Brown
- E: Earth Yellow/Green
- N: Neutral Blue
This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and electronic equipment should never be disposed ofwith general household waste but must be separated for its correct treatment and recovery. Where possible recycle your packaging.
Technical Helpline
- +44 (0)1924 893380
- www.belllighting.co.uk
- British Electric Lamps Ltd
- BELL House, Foxbridge Way, Normanton Industrial Estate Normanton, West Yorkshire. WF6 1TN
- T: +44 (0)1924 893380
- F: +44 (0)1924 894320
- E: sales@belllighting.co.uk
- www.belllighting.co.uk