OPTONICA 5893 LED Flood Light Instructions
- June 5, 2024
- OPTONICA
Table of Contents
LED FLOODLIGHT INSTRUCTION
Specifications and Technical Data sheet:
Luminaire Category: LED Floodlight
Input voltage: AC170-265V 50HZ/60HZ
Ambient Temperature: -40°C <TA<50°C
WARNING:
-
ENSURE ELECTRICITY IS SWITCHED OFF BEFORE INSTALLATION.
-
Please read through all the following instructions before installing the unit.
-
The user should prepare necessary accessories and spare parts (not provided) including a junction box.
-
The Floodlight must be earthed.
-
In the case of damage the safety shield, you must replace it immediately with tempered glass.
-
Method of attachment of the cable or cord such that any replacement can only be made by the manufacturer, his service agent or similarly qualified person.
MOUNTING
-
Do not mount a surface prone to vibrations.
-
Remove the screw which is for mounting the bracket of the fixture. Remove the bracket.(see fig.2)
-
Mark the hole position for fixing the bracket onto the wall. Drill the wall at the marked positions(screw not supplied). (see fig.3)
-
Screw the fixing bracket to the wall with a suitable screw(see flg.4)
-
Mount the bracket back to the fixture. Adjust the floodlight to the desired position and tighten the screw of the fixing bracket(see fig.5)
-
Connect your mains cable(HO5RN-F3G1.0mm2 Recommended) with the input lead of our product through the waterproof junction box.
Note the Line(-) of the lead. (see fig.5) (Need to use the junction box of IP65 or above, ensure to tighten the waterproof screw) -
Open the power to make sure if the product can be lightened. Adjust the irradiation angle according to the condition of usage.(see fig.6)
Please operate it strictly according to the instruction, otherwise the consequence is proud.
Please don’t open our products by yourself, it may causes water leakage.The
power of final interpretation belong to the manufacturer.
IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1, bl. 144,
Ground Floor; Phone: +359 2 988 45 72;