HAVIT Lightning HV9101 LED Strip Touch Panel Controller User Manual

June 3, 2024
HAVIT LIGHTNING

HAVIT Lightning HV9101 LED Strip Touch Panel Controller User Manual

Important: Read All Instructions Prior to Installation

Function introduction

Function introduction

Function introduction

Product Data

Output Signal RF signal RF signal
Power Supply 12-24VDC 100-240VAC
Power consumption 20 mA 20 mA
Operating    temperature 0-40°C 0-40°C
Relative humidity 8% to 80% 8% to 80%
Dimensions 75x120x29.1mm 75x120x29.1mm
  • Touch sensitive
  • Glass interface(white & black)
  • Compatible with all universal series RF receivers
  • Radio frequency: 916.5MHz
  • Control RGBW color
  • Control 3 zones synchronously and separately
  • Waterproof grade: Ip20

Safety & Warnings

  • DO NOT install with power applied to device.
  • DO NOT expose the device to moisture.

Wiring diagram

Wiring diagram

Operation

  1. Do wiring the wall panel & RF receiver according to wiring diagram (please refer to the instruction of RF receiver that you would like to pair with)
  2. Power on, then touch the button , indicator of the controller turned blue

Pair with RF receiver(Method 1)

Pair with RF receiver

Pair with RF receiver(Method 2)

Pair with RF receiver

Built-in 10 color changing modes are as follows:

Mode 1: Any two colors of RGB mix fade-in & fade-out
Mode 2: RGB three colors mix fade-in & fade-out
Mode 3: RGB three colors mix fade-out & fade-in
Mode 4: RGB flash
Mode 5: RGB three colors fade-in & fade-out successively
Mode 6: RGB three colors fade-in successively
Mode 7: RGB three colors fade-out successively
Mode 8: RGB three colors jump changing successively
Mode 9: R&B two colors mix fade (R in B out), then G fade-in, then R&B mix fade (R out B in), then G fade-out
Mode 10: B fade-out, then G&B mix fade (G out B in), then R&G mix fade (R out G in), then R fade-in

Operation

Installation

Installation

How to stop running mode of single color LED light caused by RGBW sender interference:

  1. When pairing single color LED light to a single color remote, it might be interfered and paired by nearby RGBW senders, which might control the single color light into running mode. The running mode can not be stopped by the paired single color remote or by delete pairing.
  2. Then we need this remote, and pair the remote to the receiver via above “Pair with RF receiver(Method 2)”, then touch the color wheel to stop the running mode.
  3. Then delete pairing and pair the receiver to the single color remote again, it can be controlled by the remote again.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

HAVIT LIGHTNING User Manuals

Related Manuals