HAVIT Lightning HV1438W Vidro LED Garden Light Instruction Manual

HAVIT Lightning HV1438W Vidro LED Garden Light

Product Specifications

Fitting Dimensions

HV1438 Driver Dimensions

Important Safety Issues

• This product must be installed by a qualified electrician according to AS/NZS 3000.
• Ensure all electrical mains are disconnected before any installation.
• Do not exceed maximum wattage restrictions for globes: 12V MR16 = 20w
• Modification of this product will void any warranty.
• Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
• When installing low voltage fittings, Voltage to fitting must be within +or- 5%h of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
• All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on the fitting. (Warranty does not cover Tea Staining)
• All o-fings and seals must be in place correctly to maintain the warranty.
• These instructions may be updated at any time due to product improvements, Please visit the website for the most current installation instructions.

Steps for Installation

1. Make sure that the electrical circuit is free of voltage (master switch off)

2. Place fittings in desired locations

3. Connect the cable-

4. Use LED Driver supplied in Kit if HV1438 Kit is purchased. – DO NOT CONNECT LIGHT FITTING DIRECT TO 240V

5. Option 1

   • Undo the screw on the terminal block and set the cover aside
   • Place garden cable through the center of the terminal block
   • Reattach cover and tighten screw making sure this is tight so cable gets pierced and the connection is made

6. Option 2

   • Remove terminal block

   • Strip back cable on both fittings and cable run and twist the positive cable from fitting to positive on the cable run, then connect neutral from fitting to neutral on the
     cable run.

   • Solder all joins using solder with either a heat gun or butane gas torch.

   • Cover connections using an adhesive-lined heat shrink or gel cap to make the connection watertight. (failure to do this step will void the warranty)

   • Heat the heat shrink or crimp the gel cap making sure all connections are covered.

7. Remove glass by twisting anti-clockwise and inserting the globe

8. Reattach the glass by twisting clockwise making sure not to overtighten as this may cause the glass to crack.

9. All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.

Steps for Changing Globes

1. Remove glass by twisting anti-lockwise, and remove the globe by grabbing the outside of the globe and pulling.
2. Re-insert the appropriate globe by inserting the 2 pins into the lamp holder and pushing down gently. (Make sure not to exceed max wattage, see product label for correct info.
3. Reattach the glass by twisting clockwise making sure not to overtighten as this may cause the glass to crack.

Must be installed by a licensed electrician

Contact Details:
143 Beauchamp Road Tel: 029381 8300 Matraville NSW 2036 Australia
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au

Warranty Terms& Conditions

Additional Information

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>