Westinghouse iGen4000cv Inverter Generator User Guide

Westinghouse iGen4000cv Inverter Generator

USER GUIDE

WARNING

This Quick Start Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product.

TOOLS YOU WILL NEED

BEFORE STARTING

1. Add Engine Oil
a. Unlock and remove the engine service cover to access the oil dipstick..
b. Remove oil dipstick.
c. Using the supplied 4-cycle engine oil and funnel, slowly add engine oil to the engine until full.
d. Do not overfill. If oil level is too high, oil will drain out through the fill plug.

2.. Add Unleaded Gasoline to Gas Tank
a. Unscrew gas cap on top of tank
b. Slowly add gasoline into the fuel tank. The gasoline level should NOT be higher than the red maximum fill ring.
c. Secure gas cap

STARTING PROCEDURE

1. Make sure all loads are disconnected from the generator and be sure the ECO mode switch is in the OFF position.

2. Turn the engine/fuel control switch to the choke (cold start) or run (warm start) position

3. Firmly grasp and pull the recoil handle slowly until you feel increased resistance. At this point, apply a rapid pull while pulling out from the inverter

4. Connect loads to the control panel receptacles

SHUTDOWN PROCEDURE

1. Make sure all loads are disconnected from the generator

2. Turn the engine/fuel control switch to the off position

NOTE: This unit has a GASOLINE OFF setting that can be used before storing the unit for long periods of time.
Refer to the user manual for details.

INVERTER MECHANICAL SPECIFICATIONS

MAINTENANCE SCHEDULE

Following the maintenance schedule is important to keep the inverter in good operating condition. The following is a summary of maintenance items by periodic maintenance intervals. Refer to the Maintenance section in the Owners Manual to find out how to properly perform maintenance.

TABLE 1: MAINTENANCE SCHEDULE

1. Change oil every month when operating under heavy load or in high temperatures.
2. Clean more often under dirty or dusty conditions.
3. Recommended service by authorized Westinghouse dealer.

ENGINE OIL

Only use 4-stroke/cycle engine oil. NEVER USE 2-STROKE/CYCLE OIL. Synthetic oil is an acceptable substitute for conventional oil.

SPARK PLUG REPLACEMENT

For customer support, scan the QR code.

Questions? Call 855.944.3571 or
visit wpowereq.com/pages/support

Specifications

• Model Number: iGen4000cv

• Running Watts: 3300

• Peak Watts: 4000

• Fuel Tank Size (L/G): 6.3/1.66

• Rated Speed (RPM): 4800

• Ignition Type: TCI

• Engine Disp (cc): 141

• Oil Capacity (L): 0.4

• Oil Type: 10W30 3%

FAQ

Question: What type of oil should I use for this inverter?

Answer: The recommended oil type is 10W30 with a 3% THD rating.

Question: What should I do if the gasoline level is too high in the fuel

tank?

Answer: If the gasoline level is too high, drain out the excess gasoline until it reaches the recommended level below the red maximum fill ring.

Question: How often should maintenance be performed on the inverter?

Answer: Refer to the maintenance schedule provided in the Owner’s Manual for detailed instructions on when and how to perform maintenance tasks.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>