LED s Lights F9969-30 LED Strip Light Instruction Manual
- June 6, 2024
- LED s Lights
Table of Contents
LED s Lights F9969-30 LED Strip Light Instruction Manual
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND SAVE THEM.AS YOU MAY NEED THEM AT A LATER DATE.
WARNING: Failure to install and wire fixture in accordance with the National Electrical Codes(NEC),all applicable Federal, State and Local electrical codes, as well as specific U.L.safety standards for the intended working environment(location/application),may cause serious personal injury, death and/or property damage. This product must be installed by a person familiar with the construction and operation of the product and the hazards involved.
CAUTION:TURN OFF POWER FROM THE MAIN CIRCUIT BEFORE INSTALLING FIXTURE. Make sure fixture is grounded per National Electrical Codes (NEC).
IMPORTANT NOTE: The safeguards and instructions appearing on this page,
are not meant to cover all possible conditions and situations that may occur.
It may be understood that common sense, cautions, and care are factors which
cannot be built into any product. The person(s) installing, operating and
responsible for the light fixture，must execute these factors.
WARNING: Risk of fire and electrical shock. Most dwellings built before
1985 have supply wires rated 60°Ｃ. Consult a qualified electrician before
installing. If supply wires are located within 3 inches of the ballast, use
wires rated at least 90°Ｃ
ASSEMBLY AND INSTALLATION
TURN OFF POWDER FROM THE MAIN CIRCUIT BEFORE INSTALLING FIXTURE.
-
To help prevent the possibility of electrical shock, the use for rubber sole shoes is recommended.
-
Exercise care, use work gloves when handling the fixture to avoid cuts or abrasions.
-
Press channel and remove channel cover. Inside you will find the lampholder(s).
-
Install fixture: Locate ceiling joints and screw in fixtures using wood screws of ap-propriate length (screws not included). Use toggle bolts for drywall mounting.
-
Electrical Connections: Connect green/or bare copper wire to the green ground wire of fixture. (Ground wire must be properly attached or unit may not work).
If quick connector not provided: Connect the white supply wire to the white fixture wire, cover them with a wire nut/or twist together and cover really well with Electrical tape. Connect the black supplier wire to the black fixture wire, cover them with a wire nut/or twist together and cover really well with Electrical tape.
If quick connector provided: Plug the Line wire to black hole in quick connector. Plug the Neutral wire to white hole in quick connector. Tips: Try to pull the wire out to test if it’s tighten enough. -
Place Channel Cover back on Housing Channel. Then place the lens on the channel cover.
-
Turn power on.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>