NINGBO PI03YK Remote Control Unit User Manual
- June 13, 2024
- Ningbo
Table of Contents
NINGBO PI03YK Remote Control Unit User Manual
NINGBO PI03YK Remote Control Unit User Manual
INSTRUCTIONS:
- Plug the receiver into a grounded-3-wire indoor outlet, and then plug the lights or devices to be controlled into the
- Make sure there is power to the outlet the receiver is plugged
- Remove the plastic battery tab from the battery compartment in the back of the remote control to activate 3V pre-installed battery.
- The red indicator light on the receiver is flicker for one minute when the indoor unit is powered on . After one minute the flicker
- I / ll / lll on the remote can severally control receiver l/ll / lll
HELPFUL TIPS:
. Make sure the receiver is plugged into a working AC outlet.
. Make sure the receiver and connected equipment are turned on.
. Make sure the remote control ON button is pushed.
. Make sure the CR2032, 3V battery in the remote control is still functioning.
BATTERY REPLACEMENT:
- On the right bottom corner of the remote use your finger to slide out the battery holder.
- Remove the spent battery and insert a new CR2032, 3v Button-Cell Battery with the “ +” polarity mark facing up.
- Slide the battery holder back
- Dispose the old battery in compliance with all applicable For detail information, contact your local solid waste authority.
WARNING:
- Do not dispose of batteries in Batteries may explode or leak.
- Keep the batteries away from children and
- Risk of
- Do not exceed electrical
- For indoor use
FCC Caution.
** This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:** This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>