VIVO Single Monitor Wall Mount Instruction Manual
- June 7, 2024
- Vivo
Table of Contents
VIVO Single Monitor Wall Mount
WARNING!
If you do not understand these directions, or if you have any doubts about the
safety of the installation, please call a qualified technician. Check
carefully to make sure there are no missing or defective parts. Improper
installation may cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual. Do not exceed
weight capacity.
We cannot be liable for damage or injury caused by improper mounting,
incorrect assembly or inappropriate use.
PACKAGE CONTENTS
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
CAUTION! DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.com, email at help@vivo-us.com, or call us at 309-278-5303.
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
ASSEMBLY STEPS
STEP 1: OPTION A: Wood Wall Installation
Use the mount (A) to mark drilling locations on the wall where a stud is
located. Using a 3/16” bit, drill 2.2” deep holes into marked locations.
Secure the mount (A) to the wall using ST6.3×55 screws (W-A) with washers
(W-C).
OPTION B: Concrete/Brick Wall Installation
Use the mount (A) to mark drilling locations on the wall. Using a
3/8” bit, drill 2.4” deep holes into marked locations. Insert concrete anchors
(W-B) into the holes and secure the mount (A) to the wall using ST6.3×55
screws (W-A) with washers (W-C).
STEP 2: Attach the plastic cover to the wall plate of the mount
(A).
STEP 3: Attach the cable clip (D) to the arm (A) as shown.
STEP 4:
OPTION A: For Flat Back Displays
Install the VESA plate (B) to the back of the TV/monitor using 12/14mm
length bolts (M-A, M-B, M-D or M-E) with D5 washers (M-G).
OPTION B: For Curved / Recessed Back Displays
Install the VESA plate (B) to the back of the TV/monitor using 16mm length
bolts (M-C or M-F) with D5 washers (M-G) and spacers (M-H).
STEP 5: Partially install one M6 nut (C) to the top screw of the VESA
plate (B) and hang over the slot in the top of the mount (A). Install the
second M6 nut, then tighten both nuts.
STEP 6: Adjust tilt support using the Allen wrench (E) and swivel joints
using the wrench (F).
STEP 7: Organize cables using the cable clip (D).
Adjust as Desired
Open Monday – Friday 7:00am – 7:00pm CST,
our dedicated support team can offer immediate assistance with rapid response
times. If any parts are received damaged or defective, please contact us. We
are happy to replace parts to ensure you have a fully functioning product.
Email: help@vivo-us.com
Live Chat: www.vivo-us.com
Phone: 309-278-5303
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
References
- Register a .US.COM domain today!
- VIVO - Desks, Monitor Mounting, and More Home & Office Solutions – VIVO - desk solutions, screen mounting, and more
- MOUNT-VW01M Single Monitor Wall Mount – VIVO - desk solutions, screen mounting, and more
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>