GlocalMe U3 Mobile Hotspot User Manual

U3 User Manual

Product Overview

1. Wi-Fi LED Indicator
2.  Battery LED Indicator
3. Signal LED Indicator
4.  Strength LED Indicator
5.  Handle position for opening
6. Power button front panel
7. Reset button
8. Type-C(Input)

Function Introduction

1. Power on Press the power button for 3 seconds.
2. Power off Press the power button for 5 seconds.
3.  Reset Press the power button for 14 seconds.
4. Restore Factory Settings： Press the reset button for 5 seconds.
5. Battery Capacity and Signal Strength: Press the power button, the battery capacity will be shown in the first 3 seconds, then the signal strength will be shown afterward.

indicator
Flashing| Service Error
Battery LED Indicator| On| The battery capacity is shown by the strength LED indicator
Flashing| Charging

Local SIM

1. Local SIM is supported by U3, Only insert Nano-SIM card (small card). Please turn off the device first if you want to insert/pull out the SIM card.
2. Use a needle to pull out the SIM cards as shown in the picture below. Please contact customer service if any issue encountered
   ※U3 device does not support SIM cards with PIN code, if you want to use this type of SIM cards, please unlock the PIN code first.

Function Introduction

Brand: GlocalMe Model No.: GLMU19A02
Box content: Device, User Manual, Type-C cable, SIM removal tool

Technical Specification:

• Size: 1266610mm
• LTE FDD: B1/2/3/4/5/7/8/9/12/13/17/ 18/19/20/25/26/28/66
• LTE TDD: B34/38/39/40/41(194M)
• WCDMA: B1/2/4/5/6/8/9/19
• GSM: 850/900/1800/1900
• Max Upload Speed: 50Mbps
•  Max Download Speed: 150Mbps
• Wi-Fi: IEEE802. 11b/g/n
• Wi-Fi Frequency: 2.4GHz
• USB port: Type-C (Input)
• Battery Capacity: 3000mAh
• Power Input: DC 5V 2A

Quick Start Guide

1. Register an Account： Scan the QR code below to download the GlocalMe App. You can register for an account after installation.
   http://www.glocalme.com/index/index/downloadPage

2. Activate Device: Use the GlocalMe app to scan the QR code on the back panel of the device.
   IMEI:123456789012345
   SSID: admin
   PWD: admin
   https://www.glocalme.com/CN/zh- CN/download/downloadPage?imei=869680022932833&pwd=66296839&type=E1

3. Purchase Package: Purchase package or top-up through the GlocalMe app.

4. Power On: Press the power button for 3 seconds.

5. Connect to GlocalMe: When When the Wi-Fi LED indicator “ ” is staying on, turn on Wi-Fi on your cell phone, select GlocalMe Wi-Fi, enter the password to connect to the internet. (Wi-Fi name and password can be seen on the back panel. as shown below)

6. Device Management: Enter “192.168.43.1” in the address bar of web browser, and enter the username and password to login. (The initial username and password are admin/admin).

Warning

Specific Absorption Rate (SAR) information. SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower the power output.
Before a new device can be made available for sale to the public, it must be tested and certified by the FCC that it does not exceed the exposure limit established by the FCC, Tests for each device are performed in positions and locations as required by the FCC. For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal and that positions the device a minimum of 1.0 cm from the body.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause.
Undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur during installation. If the device does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is suggested to try to correct the interference by the following measures:
–Reorient or relocate the receiving antenna.
–Increase the distance between the equipment and the receiver
–Connect the equipment to an outlet on a different circuit to the receiver
–Consult the manufacturer or an experienced radio/TV technician for help.

Information on the disposal and recycling of the devices.
This symbol (with or without a solid bar) on the device, batteries (if included), and/or the packaging, indicates that the device and its electrical accessories (for example, a headset, adapter,or cable) and batteries should not be disposed of as household garbage. These items should not be disposed of as unsorted municipal waste and should be taken to a certified collection point for recycling or proper disposal. For detailed information about device or battery recycling, contact your local city office, household waste disposal service, or retail store.
Disposal of the device and batteries ( if included) is subject to WEEE. Directive Recast (Directive 2012/19/EU) and Battery Dirctive (Directive 2006/66/ec). The purpose of separating WEEE and batteries from other waste is to minimize the potential environmental impacts and human health risk of any hazardous substances that may be present.

Contact Us

GlocalMe WeChat platform
https://www.facebook.com/GlocalMe/ http://weixin.qq.com/r/HUwUDE3E6BCXrQlv9xkP

Hong Kong uCloudlink Network Technology Limited
E-mail: [email protected]
Hotline: +852 8191 2660 or +86 400 699 1314 （China）
Facebook: GlocalMe
Instagram: @GlocalMeMoments
Twitter: @GlocalMeMoments
YouTube: GlocalMe
Address: SUITE 603, 6/F, LAWS COMMERCIAL PLAZA, 788 CHEUNG SHA WAN ROAD, KOWLOON, HONG KONG

This product and related system are protected by one or more of uCloudlink’s patents, details please refer to
https://www.ucloudlink.com/patents
Copyright © 2021 uCloudlink All Rights Reserved
V2.0

References

• Facebook
• GlocalMe® Official Site- Always Better Connected. ESIM Mobile Hotspot Provider.
• HyperConnâ„¢_uCloudlink | Connecting and Sharing without Limitations

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>