VITEK VT-3652 BK Juicer Instruction Manual

: June 3, 2024
: VITEK

Table of Contents

VITEK VT-3652 BK Juicer
DESCRIPTION
CLEANING AND CARE
Troubleshooting
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

VITEK VT-3652 BK Juicer

JUICE EXTRACTOR VT- 3652 BK
Electric juice extractor is intended for making fruit or vegetable juice.

DESCRIPTION

VITEK VT-3652 BK Juicer-1

Pusher
Feeding chute
Lid
Grating filter
Juice collector
Juice draining spout
Lock
Motor unit
Operation mode switch (P-0-1-2)
Pulp container
Juice cup

SAFETY MEASURES
Before using the unit, read this instruction manual carefully and keep it for future reference.
Use the unit for intended purposes only, as speci-fied in this manual. Mishandling the unit can lead to its breakage and cause harm to the user or damage to his/her property.

To avoid injuries do not remove the juice extractor lid during operation and when the unit is plugged in as well.
The maximal allowable continuous oper-ation time is not more than 5 minute with subsequent break of at least 3 min-utes.
Before using the unit for the first time, make sure that the voltage in your mains corresponds to unit operating voltage.
Place the juice extractor on a dry, flat and steady surface only.
Before using the unit for the first time, wash all removable parts that will contact processed foods thoroughly.
Be cautious when holding the grating filter in your hands, as the disc grating surface is very sharp.
Check the grating filter before every use of the juice extractor. If you find any mechanical dam-age, stop using the unit and immediately replace the grating filter.
Use the supplied removable parts only.
Do not use the unit outdoors.
Do not place the unit and the power cord near hot surfaces, heat sources or sharp edges of furniture.
Before using the unit, make sure that all parts are set properly.
You can use the juice extractor only if the juice extractor lid is fixed with the lock.
Never push products into the feeding chute with your fingers or other objects during operation. For this purpose use the pusher only.
Do not bring your face close to the open feeding chute while the unit is operating, fruit/vegetable pieces can be flung out of the feeding chute and cause harm to the user.
Never use the juice extractor without installed pulp container.
The unit is not intended for chopping or mixing of products.
Do not disassemble the slow juicer if its power plug is connected to the mains socket.
Do not touch the power plug with wet hands.
Open the lock only after the unit is switched off and the grating filter has stopped rotating.
If some moisture or juice drops appear on the juice extractor housing, switch it off, unplug it and wipe the housing with dry cloth.
After operation switch the unit off and pull the power plug out of the mains socket.
Do not allow children to touch the unit and the power cord during operation.
Do not allow children to use the unit as a toy.
This unit is not intended for usage by children.
During operation and breaks between operation cycles, the unit should be placed out of reach of children.
The unit is not intended for usage by physically or mentally disabled persons (including children) or by persons lacking experience or knowledge if they are not under supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
For children safety reasons do not leave polyethylene bags used as a packaging unattended.

Attention! Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation!

Check the power cord and plug periodically.
Never use the juice extractor if the grating filter, power cord or power plug is damaged, if the unit works improperly or after it was dropped.
Do not attempt to repair the unit. Do not disassemble the unit by yourself, if any malfunction is detected or after it was dropped, unplug the unit and apply to any authorized service center from the contact address list given in the warranty certificate and on the website www.vitek.ru.
Transport the unit in the original package only.
Keep the unit out of reach of children and disabled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, ITS COMMERCIAL USAGE AND USAGE IN PRODUCTION AREAS AND WORK SPACES IS PROHIBITED.

BEFORE THE FIRST USE
After unit transportation or storage at low temperature keep it for at least 3 hours at room temperature before switching on.

Unpack the juice extractor and remove all packaging materials that can prevent unit operation.
Check the unit for damages, do not use it in case of damages.
Before plugging the unit in make sure that the operating voltage of the unit corresponds to the voltage of your mains.

Disassemble and clean the juice extractor before usage:

Remove the pusher (1) from the lid (3) feeding chute (2).
Lower the lock (7) and remove the lid (3).
For easy removal of the grating filter (4) remove the grating filter with the juice collector (5) holding the juice collector (5) and pulling it upwards.
Wash thoroughly and dry all the removable parts (1, 3, 4, 5, 11) that will contact products.
Note: Be cautious when holding the grating filter (4) in your hands, as the disc grating surface is very sharp.

MAKING JUICE
Before the first plugging in make sure that the operating voltage of the unit corresponds to the voltage of your mains.
Fruit and vegetables meant for processing must be fresh.
Before juice extracting wash fruit/vegetables, remove inedible parts from vegetables or fruit, such as stems, hard peel or stones, for example, of cherry or peach, cut them into pieces easily fitting into the feeding chute (2).

Place the motor unit (8) on a dry, flat and steady surface.
Before unit assembling make sure that the operating mode switch is set to the position «0», and the plug is not inserted into the mains socket.
Set the juice collector (5) on the motor unit (8).
Install the grating filter (4) into the juice collector (5).
ATTENTION!
Do not use the juice extractor if you find mechanical damages of the grating filter (4).
Set the pulp container (10) behind the juice extractor.
Install the lid (3) on the juice collector (5); when installing the lid (3) make sure that the rear part of the lid (3) matches the juice collector (5) grooves and fix it with the clamp (7).
Set the juice cup (11) under the juice-draining spout (6).
Insert the power plug into the mains socket.
Switch the juice extractor on by setting the switch (9) to the position «I» (low speed), position «II» (high speed) or position «P» (pulse mode).

Notes:
Low speed «I» is intended for extracting juice from soft vegetables/fruits, such as tomatoes, ripe pears, strawberries, oranges, plums, grapes, pumpkins, onions, cucumbers etc.
High speed «II» is intended for extracting juice from hard vegetables/fruits, such as artichoke, carrot, apples, capsicum, beet, potatoes, pineapples, vegetable marrows, celery, spinach, dill, leek etc.
«P» is pulse mode, switching the juice extractor on for a short time.

ATTENTION!
To avoid the grating filter (4) stopping and motor rotor jamming during the processing of viscous or quite hard food it is recommended to use the high- speed operation mode «II» of the juice extractor.

The unit will be switched on only if all the removable parts are installed properly, and the lid (3) is fixed with the lock (7).
Feed fruit/vegetable pieces into the lid (3) feed-ing chute (2) only when the grating filter (4) is rotating.
Gradually put vegetables or fruits cut beforehand into the lid (3) feeding chute (2) and push them gently with the pusher (1). Do not press on the pusher (1) too hard as it can lead to decrease of juice amount as well as stop the grating filter (4) rotation. The slower is the fruit and vegetables processing, the higher is the juice extraction rate.
Do not put your fingers or any other foreign objects into the lid (3) feeding chute (2).
During operation, check the grating filter (4) periodically for obstruction of the mesh with pulp, if necessary wash the grating filter (4); before removing the grating filter, switch the juice extractor off and unplug it.
Control the pulp container (10) filling, if the container (10) is filled up, switch the juice extractor off, unplug it and remove the pulp from the container.

ATTENTION!
The maximal allowable continuous operation time is not more than 5 minute with subsequent break of at least 3 minutes.
After processing of 500 g hard and fibrous fruits and vegetables (citrus plants, pineapples, apples, carrots etc.) disassemble and clean the unit. Non- compliance with the requirement can cause the grating mesh blockage and will complicate the unit cleaning.

After unit operation, switch it off by setting the switch (9) to the position «0», and unplug it.

OVERHEATING PROTECTION
The overheating protection switches the elec-tric motor off if it is too hot. If the juice extractor switched off during the operation, set the operation mode switch (9) to the position “0” and unplug the unit. Let the unit cool down for 30-40 minutes and switch it on again. During the juice extractor operation maintain the timing cycles (5 minutes – operation, 3 minutes – break), do not apply excessive force to the pusher (1), do not block the air inlets on the bottom of the juice extractor body.

CLEANING AND CARE

After the end of operation or before cleaning always switch the unit off and unplug it.
Disassemble and clean the juice extractor after every usage and follow the recommendations below.

Remove the pusher (1) from the lid (3) feeding chute (2).
Lower the lock (7) and remove the lid (3).
For easy removal of the grating filter (4) remove the grating filter with the juice collector (5) holding the juice collector (5) and pulling it upwards.
It is recommended to wash all removable parts in warm water with a neutral detergent right after the unit operation.
It is more convenient to wash the grating filter (4) openings from the outside using an appropriate brush.
Be cautious when washing the grating fil-ter (4), the disc grating surface is very sharp.
Do not wash the grating filter (4) and other removable parts in a dishwasher.
Clean the motor unit (8) with a slightly damp cloth and then wipe it dry. Do not immerse the motor unit (8) into water or any other liquids; do not wash the motor unit (8) under water jet.
Do not use coarse sponges, abrasives and solvents to clean the unit.
Some products, such as carrots or beets, can dye the juice extractor’s removable parts, you can use a dry cloth dampened in vegetable oil for removing stains; after cleaning of parts wash them with warm water and a neutral detergent, then dry.

TIPS

Use only fresh fruits and vegetables, as they contain more juice.
For juice extracting you can use different vegetables (carrots, cucumbers, beets, celery stems, spinach, tomatoes) or fruits (apples, grapes, pineapples).
It is recommended to wash berries right before juice extracting, as they lose freshness quickly.
It is not necessary to remove thin peel from fruits or vegetables, remove thick peel only, for example from pineapples or beet.
When making juice from apples it is not necessary to remove apple cores.
When extracting apple juice remember that its richness depends on the apple sort.
Choose the apple sort from which you can make juice to your taste.
Drink juice right after you made it. The juice loses its taste and nutrition value during long storage in open air.
Apple juice gets dark quickly, but if you add some drops of lemon juice to it, this suspends the process of juice darkening.
If you keep juice in the refrigerator, pour it into a clean bowl with a lid to prevent it from absorbing the smell of other foods stored in the refrigerator. It is not recommended to keep juice in a metal container, as the juice can acquire corresponding flavor.
The juice extractor is not intended for processing fruits with high content of starch or pectin, such as bananas, papaya, avocado, figs, apricots, mango, red and black currants. Use other kitchen appliances to process these kinds of fruit.
The juice extractor is not intended for processing extra hard and fibrous products, such as coconuts, rhubarb or quince.

STORAGE

Perform the requirements of the CLEANING AND CARE section before taking the unit away for storage.
Keep the unit in a dry cool place out of reach of children and disabled persons.

Troubleshooting

Problem	Troubleshooting

When using the juice extractor for the first time, unpleasant smell can appear.| It is normal because some time is necessary for carbon brush lapping in motor unit.
Juice extractor does not work| 1. Make sure it is assembled properly, and the lock is in the locked position.

2. Connect any suitable unit to the socket in order to check whether voltage is available in the socket.

Juice amount has decreased rapidly| 1. The mesh filter became cluttered

– switch the juice extractor off, remove the power plug from the socket.

– when electric motor stops, check the grating filter

– clean and wash the grating filter.

Juice extractor vibrates strongly during operation.| 1. Pulp adhesion on one side of grating filter is possible.

– switch juice extractor off, remove the power plug from the socket;

– when electric motor stops, check the grating filter;

– clean and wash the grating filter.

2. Grating filter damage

– examine the grating filter, in case of damage or cracks replace the grating filter.

Juice extractor operation is accompanied by intense noise and unpleasant smell, the unit heats up strongly, smoke appears etc.| Stop using the unit immediately, disconnect it from the mains and apply to the authorized service center for testing and repairing it.

DELIVERY SET
Motor unit – 1 pc.
Pusher – 1 pc.
Lid – 1 pc.
Grating filter – 1 pc.
Juice collector – 1 pc.
Pulp container – 1 pc.
Juice cup – 1 pc.
Instruction manual – 1 pc.

TECHNICAL SPECIFICATIONS

Nominal voltage: 220-240 V ~ 50 Hz
Rated current: 1.6 A
Maximal power: 900 W

RECYCLING

The waste generated during the disposal of the unit is subject to mandatory collection and consequent disposal in the prescribed manner.
For further information about recycling of this product apply to a local municipal administration, a disposal service or to the shop where you purchased this product.
The manufacturer preserves the right to change design, structure and specifications not affecting general principles of the unit operation without a preliminary notification due to which insignificant differences between the manual and product may be observed. If the user reveals such differences, please report them via e-mail info@vitek.ru for receipt of an updated manual.
Unit operating life is 3 years

Guarantee
Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

For environment protection do not throw out the unit and the batteries with usual household waste after its service life expiration; apply to the specialized center for further recycling.

A production date of the item is indicated in the serial number on the technical data plate. A serial number is an eleven-unit number, with the first four figures indicating the production date. For example, serial number 0606ххххххх means that the item was manufactured in June (the sixth month) 2006.

https://tm.by