brennenstuhl 3125072 Rechargeable Solar LED Outdoor Light Instruction Manual

brennenstuhl 3125072 Rechargeable Solar LED Outdoor Light Instruction

Manual

Operating instructions

Rechargeable Solar LED Outdoor Light GL 400 AS
Attention: Please read these instructions for use carefully before using the product and keep them in a safe place afterwards.

SAFETY INSTRUCTIONS

Please observe the general safety instructions enclosed with the product, which can also be found at service.brennenstuhl.com.
The product is not IP44 (protected against foreign bodies and splash water)
– during the charging process
– while using the USB output
The light source cannot be replaced; if it loses its function, the entire luminaire must be disposed of.
The luminaire contains a light source of energy efficiency class E – 0172640162.

TECHNICAL DATA

Protection class: III
Protection type / Impact resistance: IP44 / IK05
Operating temperature: -10°C – +40°C
Storage temperature: -10°C – +40°C
Type GL 400 AS
Exchangeable battery type(Li-Ion)/V/mAh18650Li-Ion 3.6 V / 3000 mAh
Charging input connector USB type C
Charging input V/A 5 V / 2 A
Charging time Approx. 2.5 hPowerbank V/A 5 V / 2 A
Dimensions (cm) 12 x 12 x 10
Weight (kg) 0,4
CONTROL UNITS

Li-Ion 3.6 V / 3000 mAh

Charging input connector| USB type C
Charging input V/A| 5 V / 2 A
Charging time| Approx. 2.5 h
Powerbank V/A| 5 V / 2 A
Dimensions (cm)| 12 x 12 x 10
Weight (kg)| 0,4

CONTROL UNITS

1. Switch with switching steps
2. Charging socket
3. Charging indicator
4. Solar panel

COMMISSIONING

The product can be switched on and off using the switch (1) and the desired light level can also be set accordingly. Press several times to switch the light intensity from 100% to 50% to 10% and then to “Off”.
The lower the light output setting, the longer the light duration.

CHARGING THE BATTERY

1. To ensure optimum function, we recommend that the battery is fully discharged and fully recharged the first time it is
2. The charging socket (2) is located under the cap on the back of the
3. The charging indicator flashes during the charging When the battery is fully charged, the LED lights up permanently.
4. If the battery is not used for a long period of time, recharge it approximately every 3 months to ensure a long battery
5. The product can be operated while
6. After charging, be sure to close the charging socket again with the sealing

REPLACING THE BATTERY

1. Open the two screws with a standard Phillips
2. Remove the
3. The standard battery can now be
4. Make sure to reinsert the standard battery in the correct position indicated on the
5. Replace the
6. Close the cover again by tightening the two

POWERBANK FUNCTION

The product has a power bank function that you can use to charge devices with 5 V / 2 A. You can use the same charging socket that you use to charge the product.

SCOPE OF DELIVERY

Light, 1 m USB charging cable.

EU DECLARATION OF CONFORMITY

UKCA DECLARATION OF CONFORMITY

The declaration of conformity is deposited with the manufacturer.

DISPOSAL

Dispose of electrical appliances in an environmentally friendly manner!

Electrical appliances should not be disposed of with household waste!

In accordance with European Directive 2012/19/EU on waste electrical and electronic equipment, used electrical appliances must be collected separately and recycled in an environmentally friendly manner.
You can find out how to dispose of your old appliance from your local authority.
For further information, we recommend the Service/FAQs section on our homepage www.brennenstuhl.com.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>