brennenstuhl 1241020300 Automatic Extension Cord with Retractor Instruction Manual
- June 3, 2024
- brennenstuhl
Table of Contents
Automatic Extension Cord with Retractor
Instruction Manual
1241020300 Automatic Extension Cord with Retractor
Introduction
Please read these instructions in their entirety before commencing with the
installation. Save these instructions and pass them on to third parties, as
appropriate.
Scope of Delivery
Please check immediately after unpacking the goods whether the shipment is
complete and the merchandise is in good condition. 1 automatic cable reel and
2 wall anchors.
Specifications
General
Operating voltage | 230 V / 50 Hz |
---|---|
Child protection | yes |
Overheating protection | yes |
Pivotable | 180º |
Model KT A92 V315 DE
Total cable length | 9 + 2 metres |
---|---|
Cable type | H05VV-F3G1,5 |
Max. load: | 1,400 Watt |
Uncoiled | 2,000 Watt |
Protection type | IP20 |
The automatic cable reel is suitable for use in dry interior rooms.
Model KT A92 N315 IP44 DE / BE
Total cable length: 9 + 2 metres.
Model KT A162 N315 IP44 DE
Total cable length: 16 + 2 metres
Model KT A92 N315 IP44 DE / BE Model KT A162 N315 IP44 DE
Cable type | H07RN-F3G1,5 |
---|---|
Max. load: | 1,000 Watt |
Uncoiled | 3,500 Watt |
Protection type | IP44 |
The automatic cable reel is suitable for permanent outdoor use.
Mounting
– The automatic cable reel features a holder with two mounting holes.
– Using the holder’s mounting holes as guides, mark the location of the
boreholes for mounting.
– Drill the required holes.
– Use suitable mounting material (M 6 screws) to attach the automatic cable
reel.
Operation
– Connect the plug of the automatic cable reel to a mains socket.
– Connect an appliance to the automatic cable reel’s safety socket.
– The automatic cable reel features a cable management system with automatic
rewind capability.
– The cable snaps in place after each half-turn, and automatic rewinding
stops.
– To coil up the cable, pull the cable until it releases from the locked
position (makes no sound), then slowly let the cable rewind.
– IMPORTANT: The tractive forces are very high. Avoid uncontrolled
rewinding of the cable. Hold the cable end and slowly guide it towards the
automatic cable reel.
Overheating Protection
– The LED on the automatic cable reel lights up red to show that the
overheating protection is working.
– The LED goes out when the overheating protection is triggered (56+/-5 ºC).
– In that case, the power plug must be disconnected.
– After a short cooling-off period, you can start using the automatic cable
reel again by pressing the red button.
Safety Notes
– All installation and repair work must be carried out by a qualified
technician.
– Make sure when changing lines that the shortest possible path is used to
connect the L/N conductors to the clamps and that the earth wire is connected
to the marked clamp and is at least 12 mm longer than the other L/N
conductors.
– If necessary, the overheating protection must be replaced with a new
component with the same rated values.
– The plugs must be disconnected from the outlet before the cable is coiled or
uncoiled.
– Do not exceed the maximum load (see Specifications).
Maintenance /Cleaning
Important: Make sure the automatic cable reel is de-energized for
cleaning. To de-energise the cable reel, disconnect the safety plug from the
mains socket. This product does not require servicing. To clean the exterior
of the automatic cable reel simply wipe it with a clean, dry cloth. Make sure
the automatic cable reel does not get wet.
Dispose of electrical devices in an environmentally responsible manner!
Do not dispose of electrical devices with household rubbish! In accordance
with Directive 2012/19/EC on waste electrical and electronic equipment, used
electrical equipment must be collected separately and reused or recycled in an
environmentally responsible manner. Please contact your local authorities for
available disposal options for your worn-out device.
Addresses
Hugo Brennenstuhl GmbH & Co. KG
Seestraße 1-3 · D-72074
H. Brennenstuhl S.A.S. ·
4 rue de Bruxelles F-67170 Bernolsheim
lectra-t ag · Blegistrasse 13 · CH-6340 Baar
www.brennenstuhl.com