Connects2 CAM-31 Side View Camera User Manual
- June 6, 2024
- Connects2
Table of Contents
User Manual CAM-31
Side View Camera
PRODUCT FEATURES:
Image Sensor: 1/4” DSC
TV System: PAL
Pixels: 720 x 480
TV Lines: 420
Diagonal Degrees: 180
Illumination: 0.3 Lux
Electronic Shutter: 50/60 fps
Gamma Correction: 0.45
Video Output: 1.0V p-p 75ohm
Enhanced Performance In Low Light: Yes
Operating Temperature: -30 Degrees C to +75 Degrees C
Operating Voltage: 6-24V DC (Negative Ground)
Current Consumption: 37mA @ 13.8V
Image Adjustment: Yes (Normal/Mirror)
Camera Mounting Orientation: Vertical
DISCLAIMER:
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for
installation. Please ensure you use the correct tools to avoid damage to the
vehicle or product.
Connects2 can not be held responsible for the installation of this
product.
Technical Support
Connects2 wants to provide a fast and suitable resolution should you encounter
any technical issues. With this in mind, when contacting Connects2, try to
provide as much information as possible. This will speed up the process and
help us to help you.
Please use our dedicated online technical support center:
support.connects2.com
CONTENTS
– Camera with 3m cable to Male 2.5mm plug
– Adhesive pad and fitting accessories
– 8m camera connection cable with Female 2.5mm socket to RCA Male connector,
power, ground, and image adjustment wire
– Instructions
INSTALLATION
- Connect the Black wire to a suitable ground and the Red wire to a switched +12V supply.
- If the camera is to be used in the rear of the vehicle, the Red wire should be connected to the reversing light circuit or an interface that provides a reverse signal.
- If a mirror image view is required, do not connect the Green wire on the camera connection cable to the ground. Connecting the Green wire to the ground will provide a normal image view.
- Select a suitable location for the camera and ensure that the area is free from all cables, fuel & oil. Whenever possible, avoid locations that are subject to road dirt & water spray.
- Remove the screw located in the camera housing cover, remove the housing cover and then remove the camera.
- Attach the camera housing to the vehicle using the adhesive pad and fitting accessories. Ensure that the camera housing is securely mounted to the vehicle and refit the camera, camera housing cover, and screw.
- Connect the camera cable to the 8m camera connection cable and connect the connection cable to the display screen and ensure that the image is displayed correctly.
- Adjustment of the camera may be required to ensure that the correct angle of the image is achieved. If adjustment is required, loosen the screw located in the camera housing, adjust the camera and tighten the screw to lock the camera in position.
Subscribe to our YouTube Channel for installation guides and tips… www.youtube.com/connects2
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>