TONOR TRL20 12″ Large Selfie Ring Light Instruction Manual

TONOR TRL20 12″ Large Selfie Ring Light Instruction Manual

ABOUT THIS MANUAL

Thank you for purchasing TONOR TRL-20 Ring Light Kit, This manual is intended to help you understand all about this ring light kit and how to use it. TONOR always strives for the ultimate user experience. All our knowledge and passion for technology are incorporated into building products with high performance for you. The TONOR TRL-20 is plug-and-play, easy to install, and contains all required accessories to achieve the best user experience.

Enjoy your time !

TONOR Team

ACCESSORIES

• 12″ Ring Light with USB Power Supply 1
  

• Adjustable Metal  Tripod Stand 1
  

• Bluetooth Remote Shutter 1

• Mount Phone Holder 1
  

• Manual 1

• After-sales Card  1

KNOWING YOUR RING LIGHT

ASSEMBLY INSTRUCTION

• Unfold the tripod legs to the maxiumum width.
  

• Loosen the height adjustment knob.
  

• Move the tripod pole up or down to your desired height and screw the knob tight.
  

• Pull the locking knob, take out the removable plate and connect it to the ring light. Pull the locking knob again and put back the removable plate with the ring light.
  

• Loosen the buckles.
  

• Adjust the tripod legs to your desired height.
  

• Lock to its place.
  

• Screw the tripod mount phone holder onto the ring light and adjust to your desired angle (360 rotation).
  

USING YOUR STAND LIGHT

1. Power the light through the USB power port (5V 2A) with any USB charging adapter, power bank, or active computer USB port.
   

2. Adjust the brightness and lighting mode via the controller.

3. Turn on the Bluetooth function on your phone and search for TRL-20 to connect, and then press the corresponding Camera Button (iOS or Android) to take photos.
   

CAUTION

• For enough brightness, please ensure an input power of 5V — 2A by USB power supply.
• Switch off the device when it is not in use.
• Switch off the device before assembly and maintenance and disconnect from power supply
• Do not disassemble the device without authorization.
• Do not store the product in a high temperature environment.
• Please keep the light away from water or any other liquid to avoid electrical shock.
• Do not look directly into the light to avoid any injuries.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by person responsible for their safety.
• Do not allow to be used as a toy. Close attention is necessary when used by or near children. Children should be supervised to ensure that they do not play with the product or remote shutter.
• Do not operate any light with a damaged cord or after malfunction occurs, or damaged in any manner. Discard the light, or return it to an authorized service facility for examination or repair.
• Keep away from heat and avoid direct sunlight.

TROUBLESHOOTING

The following troubleshooting guide addresses the most common problems.

please ensure an input
power of 5V— 2A by
USB power supply.
The stand light does
not light up| No power supply
active power port.| Correctly connect to an
The stand light is not
turned on| Refer to the Using Your
Stand Light section.
LED failure| LED component failed| Please contact the
TONOR Support Team.
The tripod stand is not
stable| Not correctly installed| Make sure the knob is
tightened and the
buckles are locked to
its place.

Specifications

Yellow: 2700K -3300K
Remote Control Battery:| CR2032, 3V

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>