TONOR TW3B Wireless Microphone Instruction Manual

TONOR TW3B Wireless Microphone

Product Information

The TONOR wireless microphone is a high-quality microphone built with advanced audio technology to provide the ultimate user experience. It comes with a display screen, on/off switch, tail tube, volume control buttons, setting button, and battery compartment. The microphone operates on 2 AA batteries and can be used in a ventilated environment away from water and fire. It is important to keep the device away from other interfering sources as it is a wireless device. The microphone complies with Part 15 of the FCC Rules and FCC radiation exposure limits set forth for an uncontrolled environment.

Package Including

• 1 TONOR Wireless Microphone (TW3B)

• 01 Operating Instructions Manual

• AF : 68-1.9 MHz

• Power Supply : 2 AA batteries

• Warranty : 2 years of after-sales service

• Frequency Response : 40Hz-18Khz

• Operating Frequency : B/915.6 MHz -926.8 MHz B: 915.6 MHz 916.4 MHz 917.2 MHz 918.0 MHz 918.8 MHz 919.6 MHz 920.4 MHz 921.2 MHz 922.0 MHz 922.8 MHz 923.6 MHz 924.4 MHz 925.2 MHz 926.0 MHz 926.8 MHz

• Operating Range : Up to 60m

• Frequency Stability : ±10ppm

• SNR : ≥90dB

• Sound Distortion : ≤0.5%

• Mic Input Sensitivity : -52dB±3dB(0dB=1v/μ bar at 1KHz)

• RF Sensitivity : -95dBm

• Operating Temperature : 0˚C to +55˚C

Product Usage Instructions

1. Before using the wireless microphone, install 2 AA batteries. To install the batteries, follow these steps:
   • Take down the tail tube of the microphone.
   • Install the batteries and tighten the tail tube of the microphone. Note that the positive and negative polarity of the battery cannot be reversed.
2. To turn on/off the wireless microphone, press button 2 for 2 seconds.
3. To change the frequency displayed on the screen, press button 5.
4. To adjust the volume, press button 4 or 6.
5. After use, please place the used batteries into the recycle bin and do not litter them.

Warranty

TONOR provides 2 years of after-sales service, free replacement to products that are NOT damaged resulting from accident, alteration, misuse, negligence, or abuse. If exceeding 30 days of Amazon return policy, you can still contact TONOR through their Shopify TONORMIC. They will serve you with full sincerity.

Manufacturer Information

• EASTWEST ELECTRONIC COMMERCE CO., LIMITED | LEVEL 54 HOPEWELL CENTRE 183 QUEEN’S ROAD EAST HONG KONG
• EASTWEST ELECTRONIC COMMERCE CO US LIMITED | 3500 SOUTH DUPONT HIGHWAY, SUITE G106 DOVER, DE 19901 UNITED STATES
• LIFEWIT LIMITED | FLAT 237, 233 HIGH STREET CROYDON SURREY ENGLAND CR0 1FY UNITED KINGDOM
• Website : https://www.tonormic.com
• Email : support@tonormic.com

Made in China. Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

ABOUT THIS MANUAL

Thank you for purchasing TONOR wireless microphone. This manual is intended to help you understand all about this microphone and how to use it. TONOR always strives for the ultimate user experience. All our knowledge and passion for audio technology are incorporated into building microphones with highperformance for you. The TONOR microphone  is high quality and easy to use to achieve thebest user experience. Enjoy your microphone! TONOR Team

Package Including

TW3B

OPERATING ENVIRONMENTS & NOTES

• When using this device, keep it away from water.
• Use the device in ventilated environment, keep it away from fire.
• Since it’s a wireless device, please keep it away from other interfering sources.
• Don’t take apart the device.
• Please use the standard power supply, high voltage may damage the device.
• Please place the used batteries into the recycle bin, don’t litter them.

MICROPHONE OPERATION INSTRUCTION

As shown in above pictures

1. Display Screen
2. On/Off Switch
3. Tail Tube
4. Volume +
5. Setting Button
6. Volume –
7. Battery Compartment

Install 2*AA batteries before using the wireless microphone and installing instruction is as follows:

1. Take down the tail tube of mic.
2. Install the batteries and tighten tail tube of mic.

Note : The positive and negative polarity of battery cannot be reversed.

Instruction:

• Press button 2 for 2s to turn it on/off.
• Press the button 5, then the frequency on the screen wilI be changed.
• Press button 4 or 6 to adjust volume.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body

ISED Statement
This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance. This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator & your body

LIFEWIT LIMITED | FLAT 237, 233 HIGH STREET CROYDON SURREY ENGLAND CR0 1FY UNITED KINGDOM Lifewit GmbH | Friedenstraße 5 97072 Wuerzburg Germany

• https://www.tonormic.com
• support@tonormic.com

References

• Professional USB Microphone and Wireless Microphone – TONOR

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>