TONOR K7 Music Box Speaker User Manual

TONOR K7 Music Box Speaker

ABOUT THIS MANUAL
Thank you for purchasing TONOR karaoke machine. This manual is intended to help you understand all about this karaoke kit and how to use it, please read this instruction manual carefully before using, and keep it for future reference. TONOR always strives for the ultimate user experience. All our knowledge and passion for audio technology are incorpo­rated into building microphones and speakers with high performance for you.
Enjoy your time! TONOR Team

SAFETY INFORMATION

1. There are high voltage zones inside this unit that can cause injuries. Please do not open the unit. In case of technical failure, please contact the authorized service centre.
2. Never place the unit in the rain or in moist zones so as to avoid a fire or an electric shock.
3. This device uses a laser system. To prevent direct exposure to the laser beam, please do not open the unit or stare at the laser beam.
4. If technical maintenance is required, please contact the authorized service centre.
5. If the supply cord is damaged in any way, please have it replaced by the manufacturer, supplier or a qualified electrician.

WHAT’S IN THE BOX
Check and identify the contents of your package:

• 1 * Speaker
• 2* Microphone
• 1 Remote control
• 1 * Power cable
• 1 * Adapter
• 1 * User manual

SPEAKER PANNEL INSTRUCTIONS

Note: Please check the music and microphone volume to prevent the startup volume from being too loud.

1. 3.5mm external LINE audio input jack;

2. 6.35mm external microphone jack;

3. TF card slot for playing music and recording;

4. USS slot for playing music and recording;

5. Battery indicator(Red for charging, green for full);

6. 5V adapter jack for power supply and charging of speaker;

7. Microphone volume adjustment knob;

8. Power switch;
   Note: When the speaker is not used for a long time, please be sure to fully charge the battery.

   • Recharge every 30 days to prevent damage to the battery due to over-discharge.

9. Play control key group:

   • MODE: This machine provides 5 playing modes, namely Bluetooth, RADIO MODE, LINE IN, TF card/U disk. Press the button to switch input mode.
     Note:

   • When there is no a USB or TF card inserted, the speaker has only LINE input, Bluetooth, and Radio modes.

   • When a USB or TF card is inserted, the speaker will play the sound in the U disk or TF card by default.

   • Long press the MODE button to open or close the speaker’s voice prompts.

   • • Previous key: Click the previous song. Long press to rewind.

   • Pause/Play key

   • Next key: Click the next song. Long press to fast forward.

   • MUSIC.ORIG: To remove or restore the voice.

   • IN/OUT: To select indoor or outdoor mode.

   • TWS: True wireless stereo function, two machines can be linked at the same time.

   • REPEAT: Single Repeat/ Repeat All

   • REC: Recording key. Press to record and long press to play recordings.

   • MIC.PRI: Microphone Priority feature. When the microphone has a signal, the music volume will automatically decrease. When there is no sound from the microphone, the music volume will automatical­ly rise(This function is usually used during speech or hosting).

10. Knob adjustment area:

    • Microphone ECHO adjustment knob
    • Speaker tweeter adjustment knob
    • Speaker bass adjustment knob
    • Speaker volume adjustment knob

REMOTE CONTROL INTRODUCTIONS

1. MUTE button
2. Mode button. Mode function (select between Bluetooth, RADIO MODE, LINE IN, TF card/U disk)
3. REC button (Press to start recording. Press again to stop recording)
4. REC PLAY button
5. Volume+
6. Previous song: Click the previous song. Long press to rewind.
7. Play/Pause
8. Next song: Click the next song. Long press to fast forward.
9. Volume
10. Single Repeat/ Repeat All
11. EQ Mode Key(Choose between EQ l to EQ5)
12. Numeric buttons(Only for USB mode and TF card mode)

Note:

• Please install 2*AAA batteries before use.
• Please aim at the receiver window of the speaker When using remote control.
• The remote control distance is generally about 5 meters.

PLAYING INSTRODUTIONS

Bluetooth Mode
Press the MODE button to select the bluetooth mode. If the bluetooth is not connected, the BLUE displayed on the speaker will flash continuously. At this time, turn on the bluetooth device, search for the local bluetooth name “Tenor K7” and click to connect, and the voice prompts that the bluetooth is connect­ed(When the voice function is turned on). The BLUE displayed on the display is always on. Just select the music you want to play on. If you need to replace a new Bluetooth device, please turn off or disconnect the device on the Bluetooth device first. The BLUE on the display keeps flashing, and you can connect with a new device at this time.

Note:

• The Bluetooth transmission distance is affected by the environ­ment and other factors. The normal distance is about 10 meters. If you find broken sound or noise, please move the device closer to the speaker.
• In Bluetooth mode, only supports previous song, pause/play, next song, and do not support repeat operation.
• If the volume is not loud enough during Bluetooth mode, please turn up the volume of the Bluetooth device and use the speaker volume knob to adjust the required volume.

LINE IN MODE

1. Press MODE button to select LINE IN. Play the music of the device connected to the LINE input.
2. In LINE IN input mode, can not use the play button to switch up/down, pause, record, repeat and other operations.

USB Mode or TF Cord Mode

1. Turn on the speaker and insert the USB device, the speaker will automatically read and play the music in the USB device or TF card.
2. Press to pause or play.
3. Press key to the previous song. (Long press to rewind.)
4. Press key to the next song. (Long press to fast forward.)

TWS Function

1. Power on 2 speakers, both switch to “TWS Mode”.
2. Short Press “TWS” button for one until ( as the deputy model ), when under successful connection, LCD Display of the deputy model show “SLAU” without flicker.
3. Use your BT device to connect another unit ( as the host model), when under successful connection, LCD Display of the host model show “SLAU” without flicker.
4. Under TWS mode, you can adjust the main volume/play/pause/next song/ previous song to control the 2 speakers at the same time.

WIRELESS MICROPHONE OPERATION INSTRODUTIONS

• Please check whether the volume of the microphone is proper before turning on the speaker, otherwise it is easy to cause howling when you turn on the microphone.
• Please install 2 AA batteries before using. When the microphone is not used for a long time, please take out the batteries to prevent damaging the microphone.
• When using a handheld microphone, please do not hold the end of the tube to avoid affecting the transmitted signal.
• The normal optimal use distance of microphone should be within 15 meters.

TROUBLESHOOTING

Improper operation is often mistaken for failure or abnormal function. If you think any problem occurs on this machine, please check as follows. Sometimes the failure may occur in other components. In this case, please check other components and electrical products used. If the foult still cannot be rectified ofter completing the following checks, please contact Tonor. If the machine works abnormally due to external reasons (such as static electricity), please turn off the power and start it again to restore the normal working state.

Tr o ubl e| P oss i b l e Reaso n s| Sol u t i o n|
---|---|---|---
Speaker won’t power on| Battery is low.| Charge the battery.|
Battery damage| If it can be turned on after connecting to the power, and it cannot be turned on offer charging. It is determined that the battery is damaged, please replace the battery.|
Severely distorted sound| Too loud| Reduce volume|
No effect during karaoke| Improperly adjusted microphone e feet| Turn on the microphone ECHO adjustment knob.|
| Wrong polarity when| Check and install correctly|
The microphone| instol batteries| according to the marked polarity|
display is blank and the backlight is off.|
Critically low battery| Reftlace the battery with su ficient charge|
| Dirty or corroded| Clean or replace battery|
| battery contacts| contacts|
Speaker screams| Sound Feedback Howling| Reduce the volume.|
The microphone should not face the speaker.|
Increase the distance between the microphone and the speaker.|
Decrease the effect volume and reduce the microphone treble.|
The sound is| Beyond the effective| Back to effective distance.|
intermittent when| receiving distance|
the microphone is|
Signal interference| To repaired the microphone.|
in use.|
T r o ubl e| Po ss ibl e R e a so n s| S olu tion
---|---|---
Effective operating distance is short.| The environment is too complex.| Avoid complex environments. If there is a large metal object, brick wall and a large number of People, etc., will dramatical y reduce the effective distance between the microphone and the receiver.

FCC Statement

• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
• These limits are designed to provide reasonable protection against harmful interference in a residential installation.
• This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
• If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions

1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information

• The device has been evaluated to meet general RF exposure requirement.
• The device can be used in portable exposure condition, compliance with exposure requirements.

ISED Statement
This device contains licence-exempt transmitter(s)/receiv­er(s) that comply with Innovation, Science and Economic Develop­ment Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

• The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(8).
• The device has been evaluated to meet general RF exposure requirement.
• This equipment should be installed and operated with minimum distance 20 mm between the radiator & your body

EASTWEST ELECTRONIC COMMERCE CO., LIMITED I LEVEL 54 HOPEWELL CENTRE 183 QUEEN’S ROAD EAST HONG KONG
EASTWEST ELECTRONIC COMMERCE CO US LIMITED I 3500 SOUTH DUPONT HIGHWAY, SUITE G106 DOVER, DE 19901 UNITED STATES
LIFEWIT LIMITED I FLAT 237, 233 HIGH STREET CROYDON SURREY ENGLAND CR0 l FY UNITED KINGDOM
Life wit GmbH I FriedenstraBe 5 97072 Wuerzburg Germany
https://www.tonormic.com
support@tonormic.com
MADE IN CHINA
Points de collected sur www.quefairedemesdechets.fr

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>