TONOR TW350 Wireless Microphone Instruction Manual

UHF Wireless Microphone Instruction Manual
TW350

ABOUT THIS MANUAL

Thank you for purchasing TONOR wireless microphone. This manual is intended to help you understand all about this microphone and how to use it. TONOR always strives for the ultimate user experience. All our knowledge and passion for audio technology are  incorpo-rated into building microphones with high performance for you. The TONOR microphone is high quality and easy to use to achieve the best user experience.
Enjoy your microphone!
TONOR Team

Package Including

OPERATING ENVIRONMENTS & NOTES

| When using this device, keep it away from water.
---|---
| Use the device in ventilated environment, keep it away from fire.
| Since it’s a wireless device, please keep it away from other interfering sources.
| Don’t take apart the device.
| Please use the standard power supply, high voltage may damage the device.
| Please place the used batteries into the recycle bin, don’t litter them.

SPECIFICATIONS

Frequency Response: 40Hz-18Khz
Operating Frequency (US): 902.8-926.8MHz
Operating Frequency (UK/EU): 823-831MHz
Operating Range: Up to 60m
Frequency Stability: +10ppm
SNR: 290dB
Sound Distortion: <0.5%
Mic Input Sensitivity: -52dB+3dB(0dB=1v/u bar at 1KHz)
RF Sensitivity: -95dBm
Operating Temperature: 0°C to +55°C

MICROPHONE OPERATION INSTRUCTION

As shown in above pictures:

1. Display Screen
2. On/Off Switch
3. Tail Tube
4. Volume +
5. Setting Button
6. Volume –
7. Battery Compartment

Install 2*AA batteries before using the wireless microphone and installing instruction is as follows:

1. Take down the tail tube of mic.
2. Install the batteries and tighten tail tube of mic.

Note: The positive and negative polarity of battery cannot be reversed. Instruction :

• Press button 2 for 25 to turn it on/off.
• Press the button 5, then the frequency on the screen will be changed.
• Press button 4 or 6 to adjust volume.

RECEIVER INSTRUCTION

1. Receiving antenna
2. Power switch (long press for 2 to tum it on/off)
3. Volume adjusting button for microphone A
4. RF signal for microphone A
5. Treble adjusting button
6. Bass adjusting button
7. Echo adjusting button
8. RF signal for microphone B
9. Volume adjusting button for microphone B

As shown in above pictures :

1. ANTB
2. DCIN
3. BALB
4. MIX
5. BALA
6. ANT A

Before using the device, take out the wireless receiver from the package, and connect the following cables: firstly use the 6.35 audio cable to connect the receivers MIX’s port and other audio devices (speaker, amplifier, mixer, etc,). Secondly, erect the antenna,  and connect the power cable. Thirdly, check if microphone is connected to the receiver successfully after turning on the device.

TROUBLESHOOTING

No sound (The batteries of microphone have already been installed, but one of the microphone has on sound.)
Wireless Microphone ID Pairing Steps:

1. Make sure that the receiver and microphone are turned OFF.
2. Unscrew the microphone tail tube and install the batteries into the mic’s battery compartment.
3. Turn on the microphone, and press setting button 5 (on the microphone), until the microphone screen flashes quickly, then release setting buttons.
4. Turn on the receiver’s power button, waiting for button 4 (For Mic A) or 8 (For Mic B) signal light turn on, then press the setting button 5 (on the microphone) once. The microphone screen becomes steady and no longer flashes, the signal light on the receiver turns, indicating that the pairing is successful.
5. Tighten the microphone tail tube.
6. Pairing is now completed for one mic, then repeat 2-5 steps for another mic pairing.

Received signal with noise or interference
Change to other channels;
Check if receiving distance exceeds the maximum range.
Microphone cannot be turned on
Check if batteries are installed reversely;
Change to new batteries.

WARRANTY

TONOR provides 2 years of after-sales service, free replacement to products that are NOT damaged resulting from accident, alteration, misuse, negligence, or abuse. If exceeding 30 days of Amazon return policy, you can still contact us through our Shopify TONORMIC. We will serve you with full sincerity!

FCC STATEMENT: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that  may cause undesired operation.

Pour en savoir plus:
www.quefairedemesdechets.fr
EASTWEST ELECTRONIC COMMERCE CO.,
LIMITED
LEVEL 54 HOPEWELL CENTRE
183 QUEEN’S ROAD EAST HONG KONG
EASTWEST ELECTRONIC COMMERCE CO US
LIMITED
3500 SOUTH DUPONT
HIGHWAY, SUITE G106 DOVER, DE 19901
UNITED STATES
LIFEWIT LIMITED
FLAT 237, 233 HIGH
STREET CROYDON SURREY ENGLAND CRO
1FY UNITED KINGDOM
Lifewit GmbH
FriedenstraBe 5 97072
Wuerzburg Germany

https://www.tonormic.com
support@tonormic.com
MADE IN CHINA

Documents / Resources

| TONOR TW350 Wireless Microphone [pdf] Instruction Manual
TW350 Wireless Microphone, TW350, Wireless Microphone, Microphone
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>