Fiilex Q8 Color LR LED Frame Light User Guide
- June 6, 2024
- Fiilex
Table of Contents
Fiilex Q8 Color LR LED Frame Light User Guide
Safety Instructions
- DO NOT look into the light source. Be cautious of the high-intensity beam.
- DO NOT disassemble Q8 Color. This will void the warranty.
- DO NOT install Q8 Color in damp or wet locations.
- DO NOT obstruct the fixture’s air vents.
- Use safety cable (not included) when rigging Q8 Color overhead.
- Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
- Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
- The lamp shall be changed if it has become damaged or thermally deformed.
- The luminaire is intended for professional use only.
Parts Diagram
-
Vent Holes
-
Water Repellent Fabric
-
Yoke Bolt
-
Tilt Lock Lever
-
Beam Adjustment Knob (Spot to Flood)
-
Yoke
-
Junior Pin Receiver
-
Mount Tightening Knob
-
Latch
-
Fresnel Lens
-
Fresnel Lens Holder
-
Power Supply Unit (PSU)
-
Antenna
-
USB Type-C Port (For updating firmware)
-
USB Type-A Port (5V/1A Power)
-
Wireless Signal Indicator
-
Unlink Button (For disconnecting the wireless signal)
-
Intensity Control Knob
-
LAN Port
-
Dual Locking V-Mount
-
DMX Input (XLR-Male 5-pin)
-
DC Input Port
-
CCT/HUE Knob
-
OLED Display
-
Navigation Pad
-
GN/SAT Knob
-
Handles
-
ON/OFF Switch
-
DMX Output (XLR-Female 5-pin)
Fixture Operation
Mode Selection
Use Navigation Pad to enter MODES menu, then navigate to select the desired
mode.
Fixture Control
1 Manual / Local :
Use Intensity Control Knob or the Navigation Pad to control the parameters.
For CCT modes and HSI modes, use either CCT/HUE Knob and GN/SAT Knob or the
Navigation Pad .
2 DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or DMX OK.
Settings
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access
additional settings.
Fan speed options
| Off | The fan is completely off. (Operation time is limited.) |
|---|---|
| Variable | The fan speed varies based on light intensity. |
| Silent | The fan operates at reduced speed. |
| Full Speed | The fan operates at full speed. |
Dimming options
| Sharp | Best for flash and strobe effects. |
|---|---|
| Smooth | Best for gradual fades. |
Ethernet
Modify ArtNet and sACN settings of the fixture.
Info
View current fixture firmware versions and fixture temperature.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>