Fiilex Q5 COLOR Light User Guide
- June 12, 2024
- Fiilex
Table of Contents
Fiilex Q5 COLOR Light User Guide
Safety Instructions
- DO NOT disassemble Q5 Color. This will void the warranty.
- DO NOT install Q5 Color in damp or wet locations.
- DO NOT obstruct the fixture’s air vents.
- Use safety cable (not included) when rigging Q5 Color overhead.
- Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
- Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
- The lamp shall be changed if it has become damaged or thermally deformed.
- The luminaire is intended for professional use only.
- Do not look into the light source with any instrument that could concentrate the light output: this includes magnifiers, binoculars, telescopes, etc.
- This fixture corresponds to Risk Group 1 according to EN 62471 under normal operation condition, which considers all photobiological risks. It corresponds to Risk Group 1 according to EN 62778 under those conditions, which considers risk from blue light only.
- The light output can potentially cause eye injury if stared at for a prolonged period of time
Parts Diagram
- Vent Holes
- Water Repellent Fabric
- Power Supply Unit (PSU)
- Latch
- Fresnel Lens
- Fresnel Lens Holder
- Dual Locking V-Mount
- Handles
- Beam Adjustment Knob
- Tilt Lock Lever
- Yoke (1/4″-20 UNC Screw Hole)
- Baby/Junior Pin Receiver
- Mount Tightening Knob
- OLED Display
- Yoke Bolt
- Intensity Control Knob
- CCT/HUE Knob
- GN/SAT Knob
- USB Type-A Port (5V/1A Power)
- Navigation Pad
- ON/OFF Switch
- USB Type-C Port (For updating firmware)
- DMX Output (XLR-Female 5-pin)
- DC Input Port
- DMX Input (XLR-Male 5-pin)
Fixture Operation
Mode Selection
Use Navigation Pad to enter MODES menu, then navigate to select the desired
mode.
Fixture Control
-
Manual / Local :
Use Intensity Control Knob or the Navigation Pad to control the parameters. For CCT modes and HSI modes, use either CCT/HUE Knob and GN/SAT Knob or the Navigation Pad -
DMX / RDM :
Display shows DMX connection status, NO DMX or DMX OK.
Settings
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access additional settings.
Fan speed options
| Off | The fan is completely off. (Operation time is limited.) |
|---|---|
| Variable | The fan speed varies based on light intensity. |
| Silent | The fan operates at reduced speed. |
| Full Speed | The fan operates at full speed. |
Dimming options
| Sharp | Best for flash and strobe effects. |
|---|---|
| Smooth | Best for gradual fades. |
Info
View current fixture firmware versions and fixture temperature.
1689 Regatta Blvd. Richmond, CA 94804 |
510-620-5155 |
fiilex@fiilex.com
www.fiilex.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>