Fiilex FLXMXCLR-Z Matrix Color User Guide
- June 6, 2024
- Fiilex
Table of Contents
MATRIX COLOR
User Guide
Safety Instructions
- DO NOT look into the light source. Be cautious of the high-intensity beam.
- DO NOT disassemble Matrix Color. This will void the warranty.
- DO NOT install Matrix Color in damp or wet locations.
- DO NOT obstruct the fixture’s air vents.
- Use safety cable (not included) when rigging Matrix Color overhead.
- Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
- Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
- The lamp shall be changed if it has become damaged or thermally deformed.
- The luminaire is intended for professional use only.
Parts Diagram
1. Handle
2. Top Latch
3. Yoke Bolt
4. Tilt Lock Lever
5. Yoke
6. Baby/Junior Pin Receiver
7. Mount Tightening Knob
8. Vent Holes| 9. Buttom Latch
10. Power Supply Unit (PSU)
11. Fan Intake Vent
12. Intensity Control Knob
13. CCT/HUE Knob
14. GN/SAT Knob
15. USB Type-A Port (5V/1A Power)
16. Dual Locking V-Mount| 17. DMX Iutput (XLR-Male 5-pin)
18. OLED Display
19. Navigation Pad
20. ON/OFF Switch
21. USB Type-C Port (For updating firmware)
22. LAN Port
23. DMX Output (XLR-Female 5-pin)
24. DC Input Port
---|---|---
Fixture Operation
-
Mode Selection
Use Navigation Pad to enter MODES, then navigate through modes and select the desired mode. -
Fixture Control
1 Manual / Local :
Use Intensity Control Knob and/or the Navigation Pad to control the parameters.
For CCT modes and HSI modes, use either CCT/HUE Knob and GN/SAT Knob or the Navigation Pad .
2 DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or DMX OK.
Settings
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access additional settings.
- Fan speed options
| Off | The fan is completely off. (Operation time is limited.) |
|---|---|
| Variable | The fan speed varies based on light intensity. |
| Silent | The fan operates at reduced speed. |
| Full Speed | The fan operates at full speed. |
-
Dimming options
**** Sharp| Best for flash and strobe effects.
---|---
Smooth| Best for gradual fades. -
Ethernet
Modify ArtNet and sACN settings of the fixture. -
Info
View current fixture firmware versions and fixture temperature.
1689 Regatta Blvd. Richmond, CA 94804 |
510-620-5155 |
fiilex@fiilex.com
www.fiilex.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>